Putting participants at the centre of HIV cure research

The hydration of cement takes place within the water-filled capillary pores. However, environmental elements can disrupt this process by evaporating water from the concrete surfaces. Sealed concrete with a water-cement ratio below 0.5 experiences self-desiccation, leading to water loss. The water loss in concrete is mitigated by curing. This technique involves keeping the concrete saturated to maintain the necessary temperature and moisture conditions, to optimally fill the spaces in the cement...

Concrete members with a small surface-to-volume ratio are cured by oiling and moistening the forms before casting the concrete member. These forms can be left in place for a prolonged period to prevent moisture loss, and can be wetted if made of a material suitable for wetting. If the forms are removed early, the concrete member is moistened and covered with polythene sheets to maintain moisture. For large horizontal concrete surfaces exposed to dry weather, a temporary covering is suspended...

Accelerating concrete curing is achieved by applying heat and additional moisture. This process accelerates the hydration of the cement, resulting in an earlier strength gain in the concrete. Steam curing is a method wherein the concrete products are either transported through a chamber on a conveyor belt or encased in plastic, allowing steam at atmospheric pressure to circulate freely around them. This process begins with a phase of moist curing that typically lasts between 3 to 5 hours, after...

A mutation is a change in the sequence of bases of DNA or RNA in a genome. Some mutations occur during replication of the genome due to errors made by the polymerase enzymes that replicate DNA or RNA. Unlike DNA polymerase, RNA polymerase is prone to errors because it is not capable of “proofreading” its work. Viruses with RNA-based genomes, like HIV, therefore accrue mutations faster than viruses with DNA-based genomes. Because mutation and recombination provide the raw material...

Today, scientists agree that good research is ethical in nature and is guided by a basic respect for human dignity and safety. However, this has not always been the case. Modern researchers must demonstrate that the research they perform is ethically sound.

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between...