Related Experiment Video

Updated: Jan 29, 2026

Experimental Protocol for Biodiesel Production with Isolation of Alkenones as Coproducts from Commercial Isochrysis Algal Biomass
09:10

Experimental Protocol for Biodiesel Production with Isolation of Alkenones as Coproducts from Commercial Isochrysis Algal Biomass

Published on: June 24, 2016

21.4K

Biodiesel production through algal cultivation in urban wastewater using algal floway

Thomas Kiran Marella1, Aviraj Datta1, Mukund D Patil1

  • 1International Crop Research Institute for Semi-arid Tropics (ICRISAT), Patancheru 502 324, Telangana State, India.

Bioresource Technology
|February 18, 2019
PubMed

Keywords:
Algae flowayBiodieselDiatomsPhycoremediationWastewater

More Related Videos

Comparison of Scale in a Photosynthetic Reactor System for Algal Remediation of Wastewater05:40

Comparison of Scale in a Photosynthetic Reactor System for Algal Remediation of Wastewater

Published on: March 6, 2017

9.5K
A Standardized Procedure for Monitoring Harmful Algal Blooms in Chile by Metabarcoding Analysis09:47

A Standardized Procedure for Monitoring Harmful Algal Blooms in Chile by Metabarcoding Analysis

Published on: August 26, 2021

6.1K

Related Concept Videos

Scalar Product (Dot Product)01:11

Scalar Product (Dot Product)

The scalar multiplication of two vectors is known as the scalar or dot product. As the name indicates, the scalar product of two vectors results in a number, that is, a scalar quantity. Scalar products are used to define work and energy relations. For example, the work that a force (a vector) performs on an object while causing its displacement (a vector) is defined as a scalar product of the force vector with the displacement vector.
The scalar product of two vectors is obtained by multiplying...
27.3K
Vector Product (Cross Product)01:17

Vector Product (Cross Product)

Vector multiplication of two vectors yields a vector product, with the magnitude equal to the product of the individual vectors multiplied by the sine of the angle between both the vectors and the direction perpendicular to both the individual vectors. As there are always two directions perpendicular to a given plane, one on each side, the direction of the vector product is governed by the right-hand thumb rule.
Consider the cross product of two vectors. Imagine rotating the first vector about...
27.8K
The Phosphorus Cycle01:21

The Phosphorus Cycle

Unlike carbon, water, and nitrogen, phosphorus is not present in the atmosphere as a gas. Instead, most phosphorus in the ecosystem exists as compounds, such as phosphate ions (PO43-), found in soil, water, sediment and rocks. Phosphorus is often a limiting nutrient (i.e., in short supply). Consequently, phosphorus is added to most agricultural fertilizers, which can cause environmental problems related to runoff in aquatic ecosystems.
43.9K
Primary Production01:06

Primary Production

The total amount of energy acquired by primary producers in an ecosystem is called gross primary production (GPP). However, of this energy, producers use some for metabolic processes, and some is lost as heat, decreasing the amount of energy available to the next trophic level. The remaining usable amount of energy is called the net primary productivity (NPP). In terrestrial ecosystems, NPP is driven by climate, while light penetration and nutrient availability drive NPP in aquatic ecosystems.
25.2K
Production Efficiency01:01

Production Efficiency

Net production efficiency (NPE) is the efficiency at which organisms assimilate energy into biomass for the next trophic level. Due to low metabolic rates and less energy spent on thermoregulatory processes, the NPE of ectotherms (cold-blooded animals) is 10 times higher than endotherms (warm-blooded animals).
18.3K
The Dot Product01:26

The Dot Product

Measuring how one directional quantity affects another along a specific path involves comparing their orientation and strength. When two such quantities are represented using direction and amount, a numerical result is computed to show how much one acts along the path of the other. This result comes from a rule combining both inputs' horizontal and vertical parts and adding the results.This calculation gives a single value that grows larger when both inputs point in similar directions and...
262