Related Experiment Video
Updated: Jan 28, 2026
Physical, Chemical and Biological Characterization of Six Biochars Produced for the Remediation of Contaminated Sites
Published on: November 28, 2014
Remediation of soil co-contaminated with decabromodiphenyl ether (BDE-209) and copper by enhanced
Fu Chen1, Xiaoxiao Li2, Jing Ma3
1School of Environmental Science and Spatial Informatics, China University of Mining and Technology, Xuzhou 221008, Jiangsu Province, China; Low Carbon Energy Institute, China University of Mining and Technology, Xuzhou 221008, Jiangsu Province, China.
Abstract:
This work investigated the influences of citric acid and methyl-β-cyclodextrin (MCD) as enhancing agents during the electrokinetics (EK)-persulfate process on the remediation of soil artificially contaminated with decabromodiphenyl ether (BDE-209) and copper (Cu) with an initial concentration of 50 and 1000 mg/kg, respectively. The results clearly demonstrate the efficiency of the process while at the same time, the distribution of the residual contaminants in soil and the EK parameters were greatly influenced by the presence of persulfate, MCD and citric acid. The results show that there was significant removal of BDE-209 and Cu from the soil. MCD-assisted process gave the highest BDE-209 removal (88.6%) and the third largest Cu removal (54.3%) from the soil. Comparatively, the highest Cu removal (92.5%) and the second largest BDE-209 removal (85.6%) were achieved by the joint application of MCD and citric acid in anolyte during the EK-persulfate treatment. MCD and citric acid could increase soil electrical current and electroosmotic flow during EK. The alkalization of soil near cathode was alleviated by the acidic byproducts of persulfate decomposition which could be transported to the soil by electroosmosis and electromigration. This integration process may provide a green efficient technology for remediating co-contaminated soil.
More Related Videos
Related Concept Videos
02:23The Soil Ecosystem
02:29Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
02:36Crown Ethers
02:28Structure and Nomenclature of Ethers
Ethers are organic compounds with an ether functional group which is characterized by an oxygen atom connected to two — identical or different — alkyl, aryl, or vinyl groups. The C–O–C linkage in dimethyl ether — the simplest ether — has an approximately tetrahedral bond angle of 110.3 degrees. The oxygen atom is sp3- hybridized, with the C–O distance being about 140 pm.
Classification of Ethers
Based on their attached substituent...
01:16Contaminants and Errors
Another key consideration is determining the appropriate number of samples required to...
02:17Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...