Related Experiment Video
Updated: Jan 28, 2026

Thermal Scanning Conductometry TSC as a General Method for Studying and Controlling the Phase Behavior of Conductive Physical Gels
Published on: January 23, 2018
Changes of water state and gel characteristics of Hairtail (Trichiurus lepturus) surimi during thermal processing
Hao-Chen Ding1, Xue-Peng Li1,2, Rui-Zhi Li2
1Key Laboratory of Refrigeration and Conditioning Aquatic Products Processing, Ministry of Agriculture and Rural Affairs, Xiamen, PR China.
Abstract:
This study examined the changes of water state and gel characteristics of Hairtail surimi during thermal processing including two steps. The results showed that there were four content of water in Hairtail surimi gels. Water-holding capacity (WHC) and T23 relaxation time of water and gel strength increased from 47.01 to 78.97% and from 64.23 to 51.52 ms, respectively, and whiteness decreased from 63.87 to 55.22 during the entire thermal processing. Meanwhile, the texture properties including hardness, gumminess, and chewiness declined from 402.42 to 130.41 g, from 294.39 to103.70 g, and from 233.68 to 43.60 g, respectively, during the first step, and then increased markedly during the second step from 130.41 to 2,301.87 g, from 103.70 to 1,250.99 g, and from 43.60 to 978.51 g, respectively. Furthermore, the WHC and textural profile had positive correlation, and changes in protein secondary structure were interesting, with the α-helices decreasing significantly from 26.40 to 14.12%, while the β-sheet and the random coil structure increasing significantly from 36.28 to 44.03%, and from 10.89 to 14.31%, respectively, and β-turn structure increasing form 26.44 to 27.98% during the first step and then declining markedly during the second step, moreover β-sheet had a fine positive correlation with WHC hardness and chewiness. Overall, dense, porous and compact three-dimensional network gel structure gradually formed. In a word, during thermal processing. WHC of Hairtail surimi increased, and protein secondary structure of protein became orderly, and a fine, dense gel formed during thermal processing. Water is considered as the highest and most important chemical constituent in surimi products. During surimi gelation, water molecules exist as bulk water and motionally restricted water on the protein surface. In order to gain more insights into the surimi heating-induced gelation processing, and improve the surimi gel properties, and give same advice to manufacturing enterprise, this work was conducted to study the structural changes of protein and water state during surimi gelation processing and performed along with the monitoring of the texture, WHC and other physical characteristics of surimi gel, as well as the microstructure of surimi gel.
Related Concept Videos
Characteristics of Life
States of Water
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
Thermal expansion and Thermal stress: Problem Solving
To solve the problem, first, identify the known and unknown quantities. The initial length (L) of the bridge is 1275 m, the coefficient of linear expansion (α) for steel is 12 x 10-6/°C, and the change in temperature (ΔT) is 55...
Characteristics of Fluids
Characteristics of BJT
For input characteristics, the base-emitter voltage is varied, maintaining a constant collector-emitter voltage. This setup reveals a Shockley-type dependence of the collector current on...
Characteristics of JFET
The core of a JFET's operation is controlling drain current by modulating the gate-source voltage. When the drain and gate voltage are set to zero, the JFET exhibits no net current flow, representing a state of equilibrium. The drain current increases linearly as the...

