Related Experiment Video

Updated: Jan 28, 2026

Granulocyte-dependent Autoantibody-induced Skin Blistering
12:23

Granulocyte-dependent Autoantibody-induced Skin Blistering

Published on: October 12, 2012

10.9K

Blister beetle dermatitis caused by cantharidin in South Sudan in Op TRENTON: a case series

Caroline Linda Maynard-Burrows1, J V Mclennan2,3, T C Nicholson-Roberts4

  • 1Burns unit, Royal Centre for Defence Medicine, Birmingham, UK cazmaybuz@gmail.com.

BMJ Military Health
|March 4, 2019
PubMed

Keywords:
blister beetle dermatitisblister beetlesblister burnscantharidincantharidin toxinmilitary personnel

More Related Videos

A Suction Blister Protocol to Study Human T-cell Recall Responses In Vivo11:17

A Suction Blister Protocol to Study Human T-cell Recall Responses In Vivo

Published on: August 11, 2018

12.5K
An Experimental Study on Colorado Potato Beetle Hibernation Under Natural Conditions07:44

An Experimental Study on Colorado Potato Beetle Hibernation Under Natural Conditions

Published on: November 17, 2023

13.4K

Related Concept Videos

Cascaded Op Amps01:16

Cascaded Op Amps

Operational amplifiers (op-amps) are versatile electronic components that can be interconnected in a cascade - one after another in a linear sequence. This cascading is possible due to their infinite input resistance and zero output resistance, allowing them to maintain their input-output relationships even when connected in series.
In a cascaded system, each op-amp is referred to as a stage. The output of one stage drives the input of the subsequent stage. As the input signal passes through...
1.1K
Second-order Op Amp Circuits01:19

Second-order Op Amp Circuits

Implementing second-order low-pass filters in audio systems is crucial in refining audio signals by eliminating undesirable high-frequency noise. These filters typically involve second-order op-amp circuits configured as voltage followers, encompassing two nodes with distinct storage elements.
The analysis of such circuits follows a systematic approach, similar to the second-order RLC circuits. In practical scenarios, bulky inductors are rarely employed due to their size and weight. This means...
637
Characteristics of Practical Op Amps01:16

Characteristics of Practical Op Amps

A difference amplifier, a crucial component in numerous electronic devices, ideally amplifies only the difference-mode signal, which is the difference between two input signals. However, in practical circuits, the output voltage depends on both the differential gain and the common-mode gain.
The ratio of differential gain to the common-mode gain is defined as the common-mode rejection ratio (CMRR). This ratio quantifies the ability of operational amplifiers (op-amps) to reject common-mode...
859
Op Amp AC Circuits01:18

Op Amp AC Circuits

Within an audio system, the filter circuit plays a pivotal role in processing the amplified audio signal from an amplifier. Its primary function is significantly attenuating signal components with lower frequencies, thereby shaping the audio output. This circuit's operations are examined, focusing on the fundamental filter configuration. This configuration involves an operational amplifier arranged in an inverting setup coupled with resistors (R1 and R2) and a capacitor (C1).
488
Resistors In Series01:10

Resistors In Series

A resistor is an ohmic device that limits the flow of charge in a circuit. Most circuits have more than one resistor. If several resistors are connected together and connected to a battery, the current supplied by the battery depends on the equivalent resistance of the circuit. The equivalent resistance of a combination of resistors depends on both their individual values and how they are connected. The simplest combination of resistors is the series combination. 
In a series circuit, the...
6.4K
Series Resonance01:17

Series Resonance

The RLC circuit impedance is defined as the ratio of the supply voltage to the circuit current. Resonance in such a circuit occurs when the imaginary part of this impedance equals zero. This specific condition means that the inductive reactance is exactly equal to the capacitive reactance. The frequency at which this happens is known as the resonant frequency. Mathematically, the resonant frequency is inversely proportional to the square root of the product of the inductance (L) and capacitance...
799