VasoTracker, a Low-Cost and Open Source Pressure Myograph System for Vascular Physiology

Penelope F Lawton1, Matthew D Lee2, Christopher D Saunter1

  • 1Centre for Advanced Instrumentation, Biophysical Sciences Institute, Department of Physics, Durham University, Durham, United Kingdom.

Abstract

Related Concept Videos

Seedless Vascular Plants03:24

Seedless Vascular Plants

Seedless Vascular Plants Were the First Tall Plants on Earth
66.8K
Vapor Pressure02:34

Vapor Pressure

When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules move randomly about, they will occasionally collide with the surface of the condensed phase, and in some cases, these collisions will result in the molecules re-entering the condensed phase. The change from the gas phase to the liquid is called condensation. When the rate of condensation becomes equal to the rate of vaporization, neither the amount of the liquid nor the amount of the vapor...
40.4K
Definition and Measurement of Pressure: Atmospheric Pressure, Barometer, and Manometer02:57

Definition and Measurement of Pressure: Atmospheric Pressure, Barometer, and Manometer

Gas pressure is caused by force exerted by gas molecules colliding with the surfaces of objects. Although the force of each collision is very small, any surface of an appreciable area experiences a large number of collisions in a short time, which can result in high pressure.
43.0K
Physiological Barriers01:25

Physiological Barriers

Physiological barriers are semi-permeable cellular structures restricting drug diffusion into intracellular compartments and tissues. There are six types of physiological barriers: blood endothelial, cell membrane, blood-brain, blood-cerebrospinal fluid (CSF), blood-placenta, and blood-testis barriers.
The blood endothelial barrier is the most porous of these. It allows all small ionized, un-ionized, and lipophilic molecules to pass through the endothelial lining into the interstitial space...
5.2K
Sinusoidal Sources01:18

Sinusoidal Sources

Direct current (DC) refers to an electric current that flows in a single direction, maintaining a constant polarity. This is in contrast to alternating current (AC), which periodically changes its direction and magnitude. AC forms the backbone of modern electricity transmission and distribution systems due to its efficient long-distance transmission capabilities.
In homes, the power supplies use sinusoidal sources to provide electricity. These sources generate a voltage that varies sinusoidally...
1.2K
Source Transformation01:15

Source Transformation

Source transformation is a fundamental technique employed in circuit analysis, offering a valuable tool for simplifying complex electrical circuits. This technique involves the replacement of either a voltage source in series with a resistor by a current source in parallel with a resistor, or vice versa. The key concept here is that when the original sources are deactivated (turned off), the equivalent resistance at the circuit's end terminals remains the same.
It is essential to note that when...
11.4K