Three-dimensional evaluation of mandibular deformation during mouth opening

Deformation of the mandible presents a major challenge for many dentists, both in conventional prosthetic supraconstructions and in complex implant restorations. This study aimed to evaluate the three-dimensional (3D) deformation of the mandible in vivo with scannable impression material and an industrial optical scanner.

In the present study, 20 female and 20 male subjects were examined. In each case, two impressions were made with polyvinylsiloxane: one with the mouth slightly open, and a second with the mouth wide open. The impressions were digitized with an industrial optical scanner and transformed into a virtual model. The two corresponding models were digitally superimposed over all the teeth. Then, an individual local coordinate system was assigned to each individual tooth. Subsequently, a best-fit procedure was performed for each individual tooth. Finally, the open- and closed-mouth models were compared by calculating the differences and rotations in the individual axes. This procedure was performed individually for each tooth.

The mean deviations in the x-, y-, and z-coordinates ranged from 0.011 mm at the canines to 0.232 mm at the molars. Larger discrepancies were observed in the female subjects than in the male subjects; however, these differences were not statistically significant.

The results demonstrated that the posterior region of the mandible deformed when the mouth was maintained in a wide-open position. Therefore, this position should be avoided when performing dental impressions. Moreover, potential negative consequences of this mandibular deformation should be taken into consideration when planning wide-span fixed dental restorations.