Related Experiment Video

Updated: Jan 27, 2026

Studying Surfactant Effects on Hydrate Crystallization at Oil-Water Interfaces Using a Low-Cost Integrated Modular Peltier Device
06:31

Studying Surfactant Effects on Hydrate Crystallization at Oil-Water Interfaces Using a Low-Cost Integrated Modular Peltier Device

Published on: March 18, 2020

6.8K

Oil-in-Water fL Droplets by Interfacial Spontaneous Fragmentation and Their Electrical Characterization

Giuseppe Arrabito1, Vito Errico, Adele De Ninno2

  • 1Department of Physics and Chemistry , University of Palermo , Palermo 90128 , Italy.

Langmuir : the ACS Journal of Surfaces and Colloids
|March 16, 2019
PubMed

More Related Videos

Temperature-Controlled Assembly and Characterization of a Droplet Interface Bilayer10:11

Temperature-Controlled Assembly and Characterization of a Droplet Interface Bilayer

Published on: April 19, 2021

4.2K
Water in Oil Emulsions: A New System for Assembling Water-soluble Chlorophyll-binding Proteins with Hydrophobic Pigments11:26

Water in Oil Emulsions: A New System for Assembling Water-soluble Chlorophyll-binding Proteins with Hydrophobic Pigments

Published on: March 21, 2016

15.2K

Related Concept Videos

Spontaneity02:21

Spontaneity

A spontaneous process is one that occurs naturally under certain conditions. A nonspontaneous process, on the other hand, will not take place unless it is “driven” by the continual input of energy from an external source. Processes have a natural tendency to occur in one direction under a given set of conditions. Water will naturally flow downhill (spontaneous process), but uphill flow (nonspontaneous process) requires outside intervention such as the use of a pump. Iron exposed to...
29.7K
Habitat Fragmentation02:31

Habitat Fragmentation

Habitat fragmentation describes the division of a more extensive, continuous habitat into smaller, discontinuous areas. Human activities such as land conversion, as well as slower geological processes leading to changes in the physical environment, are the two leading causes of habitat fragmentation. The fragmentation process typically follows the same steps: perforation, dissection, fragmentation, shrinkage, and attrition.
21.3K
Interfacial Electrochemical Methods: Overview01:06

Interfacial Electrochemical Methods: Overview

Interfacial electrochemical methods focus on the phenomena occurring at the boundary between an electrode and a solution, as opposed to bulk methods that concentrate on the solution's overall properties. These interfacial methods are classified as either static or dynamic based on the presence of a nonzero current in the electrochemical cell and the consistency of analyte concentrations. Static methods, such as potentiometry, measure the cell's potential without any significant current...
859
Spontaneous and Induced Mutations01:30

Spontaneous and Induced Mutations

Spontaneous mutations arise infrequently during DNA replication due to errors in the process. A key factor behind these errors is tautomeric shifts in nitrogenous bases, where bases transition from keto to enol forms or amino to imino forms. This shift can alter base-pairing rules, leading to mutations. Additionally, reactive oxygen species (ROS) arising from aerobic metabolism can damage DNA, resulting in depurination (loss of a purine base) or depyrimidination (loss of a pyrimidine base).
2.2K
States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
56.7K
Determining Electric Field From Electric Potential01:12

Determining Electric Field From Electric Potential

The electric field and electric potential are related to each other. If the electric field at various points in the region of interest is known, it can be used to calculate the electric potential difference between any two points. Similarly, if the electric potential is known for various points, then it is possible to calculate the electric field.
In general, regardless of whether the electric field is uniform, it points in the direction of decreasing potential because the force on a positive...
5.0K