Related Experiment Video
Updated: Jan 27, 2026
Synthesis and Catalytic Performance of Gold Intercalated in the Walls of Mesoporous Silica
Published on: July 9, 2015
Structure and Catalytic Activities of Gold Nanoparticles Protected by Homogeneous Polyoxyethylene Alkyl Ether Type
Shiho Yada1, Tomokazu Yoshimura1
1Department of Chemistry, Faculty of Science , Nara Women's University , Kitauoyanishi-machi , Nara 630-8506 , Japan.
Abstract:
Gold nanoparticles were prepared in aqueous solutions containing four homogeneous polyoxyethylene (EO) alkyl ether type nonionic surfactants: octaoxyethylene dodecyl ether (C12EO8), methoxyoctaoxyethylene dodecyl ether (C12EO8OMe), ethoxyoctaoxyethylene dodecyl ether (C12EO8OEt), and trioxypropylene-octaoxyethylene dodecyl ether (C12EO8PO3). The sizes of obtained gold nanoparticles were almost independent of the terminal group in the EO surfactants; and the average sizes of nanoparticles prepared by surfactants with hydroxy, methoxy, ethoxy, and trioxypropylene terminal groups at [surfactant]:[Au3+] = 1:1 were 5.1 ± 1.2, 8.1 ± 1.4, 6.4 ± 2.1, and 8.6 ± 2.9 nm, respectively. The gold nanoparticles easily aggregated together according to the increasing hydrophobicity of hydroxy < methoxy ethoxy < trioxypropylene terminal groups. Highly stable dispersed nanoparticles were observed with hydroxy group in the EO terminal group. On the other hand, introducing hydrophobic moiety to the hydroxy group resulted in aggregated nanoparticles because of the interaction between the hydrophobic groups of a protective agent for the gold nanoparticles. For the reduction reaction of p-nitrophenol and 1,1-diphenyl-2-picrylhydrazyl (DPPH) radical scavenging reaction, catalytic activities of the prepared gold nanoparticles decreased by the introduction of methoxy, ethoxy, or trioxypropylene to the hydroxy group of the EO type surfactant. Thus, a significant correlation was observed between the structure of gold nanoparticles and their catalytic activities.
Related Concept Videos
02:18Ethers to Alkyl Halides: Acidic Cleavage
02:28Structure and Nomenclature of Ethers
Ethers are organic compounds with an ether functional group which is characterized by an oxygen atom connected to two — identical or different — alkyl, aryl, or vinyl groups. The C–O–C linkage in dimethyl ether — the simplest ether — has an approximately tetrahedral bond angle of 110.3 degrees. The oxygen atom is sp3- hybridized, with the C–O distance being about 140 pm.
Classification of Ethers
Based on their attached substituent...
02:29Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
01:23Test for Homogeneity
02:36Crown Ethers
01:28Types of Non-structural Cracks in Concrete
Plastic shrinkage cracks typically form within hours after the concrete is poured. The concrete's surface dries faster than the bottom, creating tensile stress that the still-plastic concrete cannot withstand, leading to diagonal or randomly patterned cracks on the concrete surface.