Related Experiment Video
Updated: Jan 27, 2026

Chromatographic Fingerprinting by Template Matching for Data Collected by Comprehensive Two-Dimensional Gas Chromatography
Published on: September 2, 2020
New approaches to monitor semi-volatile organic compounds released during coffee roasting using flow-through/active
Fábio Junior Moreira Novaes1, Ademário Iris da Silva Junior2, Chadin Kulsing3
1Universidade Federal do Rio de Janeiro, Instituto de Química, Laboratório de Análise de Aromas, Avenida Athos da Silveira Ramos, 149, Rio de Janeiro, RJ 21941-895, Brazil.
Abstract:
A novel dynamic approach is described to profile volatile organic compound (VOC) and semi-VOC (SVOC) emission during coffee roasting aimed at analysing components present in the roasting plume, and to monitor their evolution during the process. Two sorbents - coconut shell charcoal (CSC) and styrene-divinylbenzene resin (XAD-2) - were evaluated while collecting substances in four sequential time intervals (0-3, 3-6, 6-9 and 9-12 min). Extracted VOCs (<200 Da) and SVOCs were analysed by gas chromatography (GC), and comprehensive two-dimensional gas chromatography (GC × GC) with flame ionisation (FID) and time-of-flight mass spectrometry (TOFMS) detection. Results showed CSC extraction presented poor recovery of VOCs and SVOCs released during roasting. However, XAD-2 was able to collect both groups, including SVOCs of >400 Da. GC × GC resolved many co-eluting compounds observed in 1D GC and allowed chemical group type cluster analysis, revealing that many non-polar VOCs are observed within the 0-3 min interval, and that the release of polar and higher molar mass SVOCs were mostly found within the 3-6 min interval. These group-type cluster analyses offer a broad spectrum chemical profile of the released substances. It may also reveal detailed insights into the roast process evolution over time.
More Related Videos
Related Concept Videos
Gas Chromatography: Sample Injection Systems
Two primary injection methods are used...
Organic Compounds
Gas Chromatography: Introduction
In GC, a sample is vaporized and mixed with an inert carrier gas (the mobile phase), which transports it through a...
Gas Chromatography: Overview of Detectors
A non-destructive detector allows a sample to be analyzed without altering or consuming it, meaning the sample can be collected after detection for further analysis. Examples include thermal conductivity detectors and...
Gas Chromatography: Types of Detectors-II
Gas Chromatography: Types of Detectors-I
TCD is the earliest and most widely used detector that operates by measuring the changes in the thermal conductivity of the carrier gas. When a sample compound enters the detector,...

