Related Experiment Video

Updated: Jan 27, 2026

AC Electrokinetic Phenomena Generated by Microelectrode Structures
20:38

AC Electrokinetic Phenomena Generated by Microelectrode Structures

Published on: July 28, 2008

11.9K

Experimental and Numerical Investigation of Mechanical and Thermal Effects in TiNi SMA during Transformation-Induced

Vladimir Dunić1, Elżbieta A Pieczyska2, Zbigniew L Kowalewski3

  • 1Faculty of Engineering, University of Kragujevac, Sestre Janjić 6, 34000 Kragujevac, Serbia. dunic@kg.ac.rs.

Materials (Basel, Switzerland)
|March 20, 2019
PubMed

Keywords:
TiNi shape memory alloyinfrared cameramartensitic transformationphase transformation-induced creeptemperature changethermo-mechanical coupled numerical analysisthermomechanical couplings

More Related Videos

Methods of Ex Situ and In Situ Investigations of Structural Transformations: The Case of Crystallization of Metallic Glasses08:55

Methods of Ex Situ and In Situ Investigations of Structural Transformations: The Case of Crystallization of Metallic Glasses

Published on: June 7, 2018

8.9K
An Experimental Protocol for Studying Mineral Effects on Organic Hydrothermal Transformations06:50

An Experimental Protocol for Studying Mineral Effects on Organic Hydrothermal Transformations

Published on: August 8, 2018

6.0K

Related Concept Videos

Effects of Creep01:25

Effects of Creep

Creep in concrete, the gradual deformation under prolonged stress, significantly impacts the integrity of structures. For reinforced concrete beams, it can be a vital design consideration, as it increases deflection, sometimes necessitating additional design measures. In columns, especially slender ones under eccentric loads, creep can cause buckling, compromising their stability. However, creep can be beneficial in indeterminate structures by mitigating stresses that arise from shrinkage,...
434
Creep in Concrete01:22

Creep in Concrete

Creep refers to the time-dependent increase in strain under a sustained load, excluding other time-dependent deformations associated with shrinkage, swelling, and thermal expansion in concrete. The primary mechanism behind creep involves the loss of physically adsorbed water from the calcium silicate hydrate within the hydrated cement paste. This process is further exacerbated by concrete's non-linear stress-strain relationship, microcrack development in the interfacial transition zone, and...
1.2K
Factors Affecting Creep01:28

Factors Affecting Creep

In normal-weight aggregate concrete, the hardened cement paste is the primary contributor to creep, whereas the aggregates, being stiffer than the cement paste, are more resilient to stress-induced deformation. The stiffness of the aggregates is defined by their modulus of elasticity, and the more voluminous they are in the concrete, the less it will creep.
Further, the water/cement ratio is critical, as a lower ratio increases concrete strength, thus reducing creep. The strength of the...
451
Numerical Calculations01:24

Numerical Calculations

In engineering applications, the representation of the numerical value is critical. Presenting or reporting the answer is one of the essential parts of engineering practices. Numerical calculations are performed using handheld calculators or computers since numerically accurate answers are always preferred.
The solution to a problem is obtained using different methods. While manually solving algebraic symbols is one of the most common methods, the graphical method is often preferred. Computers...
1.2K
Pilot and Numeric Relaying01:21

Pilot and Numeric Relaying

Pilot relaying is a type of differential protection used in power systems. It compares electrical quantities at the terminals of equipment via a communication channel instead of direct relay interconnection. This method is essential for transmission lines where the terminals are far apart, typically up to 80 km for lines with 69 to 115 kV ratings. Four types of communication channels are used for pilot relaying:
487
Bacterial Transformation01:33

Bacterial Transformation

In 1928, bacteriologist Frederick Griffith worked on a vaccine for pneumonia, which is caused by Streptococcus pneumoniae bacteria. Griffith studied two pneumonia strains in mice: one pathogenic and one non-pathogenic. Only the pathogenic strain killed host mice.
Griffith made an unexpected discovery when he killed the pathogenic strain and mixed its remains with the live, non-pathogenic strain. Not only did the mixture kill host mice, but it also contained living pathogenic bacteria that...
59.7K