Influence of Cellulose Charge on Bacteria Adhesion and Viability to PVAm/CNF/PVAm-Modified Cellulose Model Surfaces

A contact-active antibacterial approach based on the physical adsorption of a cationic polyelectrolyte onto the surface of a cellulose material is today regarded as an environment-friendly way of creating antibacterial surfaces and materials. In this approach, the electrostatic charge of the treated surfaces is considered to be an important factor for the level of bacteria adsorption and deactivation/killing of the bacteria. In order to clarify the influence of surface charge density of the cellulose on bacteria adsorption as well as on their viability, bacteria were adsorbed onto cellulose model surfaces, which were modified by physically adsorbed cationic polyelectrolytes to create surfaces with different positive charge densities. The surface charge was altered by the layer-by-layer (LbL) assembly of cationic polyvinylamine (PVAm)/anionic cellulose nanofibril/PVAm onto the initially differently charged cellulose model surfaces. After exposing the LbL-treated surfaces to Escherichia coli in aqueous media, a positive correlation was found between the adsorption of bacteria as well as the ratio of nonviable/viable bacteria and the surface charge of the LbL-modified cellulose. By careful colloidal probe atomic force microscopy measurements, it was estimated, due to the difference in surface charges, that interaction forces at least 50 nN between the treated surfaces and a bacterium could be achieved for the surfaces with the highest surface charge, and it is suggested that these considerable interaction forces are sufficient to disrupt the bacterial cell wall and hence kill the bacteria.