Transversus thoracis muscle plane block in cardiac surgery: a pilot feasibility study

Satoru Fujii1, Matthew Roche2, Philip M Jones2,3

  • 1Department of Anesthesia and Perioperative Medicine, London Health Sciences Centre, Western University, London, Ontario, Canada satoru.fujii@lhsc.on.ca.

Abstract

Related Concept Videos

Structure of Cardiac Muscles01:13

Structure of Cardiac Muscles

Cardiac muscle, or myocardium, is a specialized type of muscle found exclusively in the heart. Its unique structural and functional characteristics enable the heart to perform its vital role of pumping blood throughout the body continuously and rhythmically. The cardiac muscle cells, or cardiomyocytes, possess an endomysium and perimysium but do not have an epimysium.
Compared to skeletal muscles, cardiac muscle cells are small and mostly have a single nucleus. Additionally, they are usually...
16.8K
Specialized Characteristics of Cardiac Muscles01:27

Specialized Characteristics of Cardiac Muscles

The primary role of cardiac muscles is to propel blood throughout the cardiovascular system. The cardiac muscle cells, or cardiomyocytes, exhibit specialized characteristics that allow them to perform this function.
Cardiac muscle cells are smaller than skeletal muscles, averaging 10–20 mm in diameter and 50–100 mm in length. However, they have large energy demands for continuous contraction and relaxation. This energy is almost exclusively derived from aerobic metabolism of energy...
4.0K
Pilot and Numeric Relaying01:21

Pilot and Numeric Relaying

Pilot relaying is a type of differential protection used in power systems. It compares electrical quantities at the terminals of equipment via a communication channel instead of direct relay interconnection. This method is essential for transmission lines where the terminals are far apart, typically up to 80 km for lines with 69 to 115 kV ratings. Four types of communication channels are used for pilot relaying:
487
Work Done Over an Inclined Plane01:11

Work Done Over an Inclined Plane

The center-of-mass framework helps to easily describe the work done on rigid bodies. Since the internal forces in a rigid body do no work, they can be ignored, and the external forces can be considered in the work-energy theorem.
The work done by gravity to move a rigid body, or the work done by an opposing force to move a rigid body against gravity, can be calculated using the center-of-mass framework. It is the line integral of the force of gravity over the path, considered positive if...
3.9K
Body Planes01:06

Body Planes

Body planes in anatomy are imaginary flat surfaces used as reference points to divide the body into sections for anatomical study. These planes are essential for understanding the orientation, relationships, and spatial organization of anatomical structures.
The sagittal plane is the plane that divides the body or an organ vertically into right and left sides. If this vertical plane runs directly down the middle of the body resulting in equal division, it is called the midsagittal or median...
31.6K
Transformation of Plane Stress01:18

Transformation of Plane Stress

Studying stress transformation is essential in understanding how stress components within a material, like a cube under plane stress, change with rotation. This change is analyzed by considering a prismatic element within the cube. As the element rotates, the stress components acting on it—both normal and shearing stresses—change in magnitude and orientation. This change is quantified using trigonometric functions of the rotation angle, relating the forces acting on the rotated element's...
712