Energy Dissipation in Resynchronization Therapy: Impact of Atrioventricular Delay
Daniel Rodríguez Muñoz1, José Luis Moya Mur1, Javier Moreno1
1Cardiology Department, University Hospital Ramón y Cajal, Madrid, Spain.
Background:
Optimal atrioventricular delay (AVD) achieves maximum cardiac output in patients undergoing cardiac resynchronization therapy (CRT). Nonoptimal AVD decreases left ventricular (LV) end-diastolic volume and causes loss of flow momentum prior to LV ejection.
Objective:
We investigated the potential role of energy dissipation (ED) in these changes in cardiac output through the study of intraventricular flow. We hypothesized that short and long AVD increases ED when compared with optimal AVD by altering the physiologic flow mechanics that preserve kinetic energy in the LV.
Methods:
Forty-four patients under CRT underwent echocardiographic LV flow analysis under optimal, short, and long AVD. LV ED and vortical flow in the inflow-outflow tract were studied during the end-diastolic and early systolic period, and paired comparisons were obtained between optimal and nonoptimal values.
Results:
ED in the left ventricle was minimal in optimal AVD and significantly increased with nonoptimal values (79.1 ± 27.5 J/m·sec in optimal AVD vs 96.5 ± 34.7 J/m·sec in short AVD; n = 18, P = .006; 123.3 ± 67.6 J/m·sec in optimal AVD vs 292.4 ± 202.5 J/m·sec in long AVD; P < .001). Increase in ED occurred due to inadequate flow redirection toward the outflow tract in short AVD and due to both turbulence and prolonged ineffective flow rotation in long AVD.
Conclusions:
Optimal AVD in resynchronization therapy favors physiological vortex flow patterns in the left ventricle during the end-diastolic and early systolic period. These patterns are altered when nonoptimal values are programmed, increasing ED.
Related Concept Videos
Power Dissipated in a Circuit: Problem Solving
The simplest combinations of resistors are series and parallel connections. In a series circuit, the first resistor's output current flows into the second resistor's input; therefore, each resistor's current is the same. Thus, the equivalent resistance is the algebraic sum of the resistances. The current through the circuit can be found from Ohm's law and is equal to the...
What is Energy?
Free Energy
Impact of Groups on Groups
Energy Basics
Internal Energy


