Related Experiment Video
Updated: Jan 27, 2026

Low-energy Cathodoluminescence for OxyNitride Phosphors
Published on: November 15, 2016
Luminescent properties and characterisation of LaB3O6:Eu3+ phosphor synthesized using the combustion method
1Department of Ceramic, Faculty of Arts, Cukurova University, 01330, Adana, Turkey.
Abstract:
Luminescent host materials which have LaB3O6 crystal structure were prepared and their structural and luminescent properties were analysed using the combustion method. Therefore, the measurements were performed at various temperatures. Phase impurity and optimum conditions were particularly determined at 900 °C for the host material prepared. Phase structures and morphological properties of the host material were analysed by X-ray diffraction (XRD) and scanning electron microscopy (SEM). LaB3O6 was observed to have monoclinic crystal structure. Photoluminescence (PL) method was used to analyse its emission properties. Thermoluminescence (TL) glow curves were recorded; starting from room temperature (RT) up to 450 °C at a constant increasing heating rate of 1 °C/s using a Lexsyg smart TL/OSL reader.
Related Concept Videos
Internal Combustion Engine
Physical and Chemical Properties of Matter
Properties of Transition Metals
Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified...
Convolution Properties II
The width property indicates that if the durations of input signals are T1 and T2, then the width of the output response equals the sum of both durations, irrespective of the shapes of the two functions. For instance, convolving two rectangular pulses with durations of 2 seconds and 1 second results in a function with a width of 3 seconds.
The area property asserts that the area under the...
Properties of DTFT I
The linearity property of DTFTs is fundamental. If two discrete-time signals are multiplied by constants a and b respectively, and then combined to...

