Temperature-Dependent DART-MS Analysis of Sexual Lubricants to Increase Accurate Associations

Candice Bridge1,2, Mark Marić3

  • 1Department of Chemistry, University of Central Florida, 4000 Central Florida Blvd, Orlando, FL, 32816, USA. cbridge@ucf.edu.

Related Concept Videos

Increased Body Temperature01:25

Increased Body Temperature

A body temperature above  38°C  (100.4 °F) is known as fever or pyrexia, and a person with fever is termed 'febrile.' Typically, the hypothalamus, a part of the brain that acts as the body's thermostat, regulates body temperature through a thermoregulatory setpoint. It receives signals from cold and warm thermal receptors throughout the body and adjusts the body's temperature accordingly. Fever occurs when this hypothalamic setpoint is altered, usually in...
6.5K
Temperature Dependence on Reaction Rate02:55

Temperature Dependence on Reaction Rate

The Collision Theory
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...
88.7K
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
377
Sexually Transmitted Infections01:26

Sexually Transmitted Infections

Sexually transmitted infections (STIs) are diseases transmitted primarily through unsafe sexual interactions. Bacteria, viruses, or parasites cause them and can result in severe health complications if untreated.ChlamydiaThe bacterium Chlamydia trachomatis is responsible for the disease Chlamydia, the most common STI in the United States. This peculiar pathogen requires human cells to reproduce, residing intracellularly. The initial infection often goes unnoticed because it typically does not...
972
Design Example: Deciding Thickness of Lubricating Fluid in a Shaft01:23

Design Example: Deciding Thickness of Lubricating Fluid in a Shaft

Effective lubrication between a rotating shaft and its bearing housing is essential in rotating machinery to minimize friction, wear, and energy loss. With carefully controlled thickness and viscosity, the lubricant layer prevents metal-to-metal contact, ensuring smooth operation.
To calculate the required thickness of the lubricant layer, the tangential velocity at the shaft's surface must first be determined. This velocity is calculated by converting the rotational speed to angular velocity...
334
Effects of Temperature on Free Energy02:11

Effects of Temperature on Free Energy

The spontaneity of a process depends upon the temperature of the system. Phase transitions, for example, will proceed spontaneously in one direction or the other depending upon the temperature of the substance in question. Likewise, some chemical reactions can also exhibit temperature-dependent spontaneities. To illustrate this concept, the equation relating free energy change to the enthalpy and entropy changes for the process is considered:
28.0K