Simultaneous detection of multiple NT-proBNP clinical samples utilizing an aptamer-based sandwich assay on an

Anirban Sinha1, Priya Gopinathan, Yi-Da Chung

  • 1Institute of NanoEngineering and Microsystems, National Tsing Hua University, Hsinchu, Taiwan. gwobin@pme.nthu.edu.tw.

Lab on a Chip
|April 4, 2019
PubMed

Related Concept Videos

Multiple Allele Traits01:49

Multiple Allele Traits

The Concept of Multiple Allelism
38.0K
Multiple Regression01:25

Multiple Regression

Multiple regression assesses a linear relationship between one response or dependent variable and two or more independent variables. It has many practical applications.
Farmers can use multiple regression to determine the crop yield based on more than one factor, such as water availability, fertilizer, soil properties, etc. Here, the crop yield is the response or dependent variable as it depends on the other independent variables. The analysis requires the construction of a scatter plot...
3.8K
Definite Integral01:29

Definite Integral

Consider a real-valued function defined on a closed interval. One of the fundamental objectives in calculus is to determine the area under the graph of such a function. When an exact computation is not readily available, this area can be estimated by dividing the interval into a finite number of equal subintervals. Each subinterval corresponds to a rectangle whose width is the length of the subinterval and whose height is determined by the value of the function at a selected point within that...
53
Indefinite Integrals01:25

Indefinite Integrals

The water inflow rate into a storage tank is not constant but increases over time. Initially, the pump delivers water at a rate of 5 L/min. However, the inflow rate increases by 2 L/min for each additional minute due to rising pressure or system adjustments. This scenario can be described mathematically by a linear function:It is necessary to integrate the inflow rate function to measure the total volume of water added to the tank over time. The total water volume V(t) is obtained by performing...
61
Integrator and Differentiator01:13

Integrator and Differentiator

Op-amp circuits have significant applications in various fields, including automotive engineering. One such application is cruise control systems in cars, where op-amp circuits are integral for maintaining a constant speed. In these systems, op-amps function as both integrators and differentiators.
An integrator within an op-amp circuit produces an output directly proportional to the integral of the input signal. This is achieved by replacing the feedback resistor in a typical inverting...
1.4K
Deformation of Member under Multiple Loadings01:11

Deformation of Member under Multiple Loadings

When a rod is made of different materials or has various cross-sections, it must be divided into parts that meet the necessary conditions for determining the deformation. These parts are each characterized by their internal force, cross-sectional area, length, and modulus of elasticity. These parameters are then used to compute the deformation of the entire rod.
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
457