Pore condensation and freezing is responsible for ice formation below water saturation for porous particles

Robert O David1, Claudia Marcolli2, Jonas Fahrni3

  • 1Department of Environmental Systems Science, Institute for Atmospheric and Climate Science, Swiss Federal Institute of Technology (ETH) Zürich, 8092 Zürich, Switzerland; zamin.kanji@env.ethz.ch david@alumni.ethz.ch.

Related Concept Videos

C–C Bond Formation: Aldol Condensation Overview01:10

C–C Bond Formation: Aldol Condensation Overview

Aldol condensation is an important route in synthetic organic chemistry used to generate a new carbon–carbon bond under basic or acidic conditions. The aldol condensation reaction presented in Figure 1 constitutes an aldol addition reaction followed by the dehydration process.
16.2K
Solution Equilibrium and Saturation01:59

Solution Equilibrium and Saturation

Imagine adding a small amount of sugar to a glass of water, stirring until all the sugar has dissolved, and then adding a bit more. You can repeat this process until the sugar concentration of the solution reaches its natural limit, a limit determined primarily by the relative strengths of the solute-solute, solute-solvent, and solvent-solvent attractive forces. You can be certain that you have reached this limit because, no matter how long you stir the solution, undissolved sugar remains. The...
21.7K
States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
56.5K
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
14.8K
Phase Transitions: Vaporization and Condensation02:39

Phase Transitions: Vaporization and Condensation

The physical form of a substance changes on changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. Vaporization occurs when the thermal motion of the molecules overcome the intermolecular forces, and the molecules (at the surface) escape into the gaseous state. When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules...
20.8K
Aldol Condensation vs Claisen Condensation01:33

Aldol Condensation vs Claisen Condensation

Aldol condensation is an acid or base-catalyzed condensation between aldehydes or ketones to give an α,ꞵ-unsaturated carbonyl compound. A base-promoted condensation between ester molecules to produce a ꞵ-ketoester is known as the Claisen condensation. In the presence of a base, both reactions involve deprotonation of the acidic α hydrogen to produce the corresponding enolates. The nucleophilic enolates attack their respective nonenolized carbonyl compound forming a tetrahedral...
7.8K