Related Experiment Video
Updated: Jan 26, 2026

Characterization and Application of Passive Samplers for Monitoring of Pesticides in Water
Published on: August 3, 2016
Solid phase extraction of pesticides from environmental waters using an MSU-1 mesoporous material and determination
L Kharbouche1, M D Gil García2, A Lozano2
1Department of Chemistry, University Ahmed Ben Bella 1, Oran, Algeria.
Abstract:
This paper describes the synthesis of a silica based MSU-1 mesoporous solid and its application as sorbent in solid-phase extraction to pre-concentrate thirteen pesticides of low-high polarity (methomyl, cymoxanil, carbofuran, monolinuron, isoproturon, methidathion, methiocarb, malathion, phosalone, diazinon, penconazole, neburon and chlorotoluron) in ground and river water. The synthesis was based in an H-bonding interaction assembling (I0N0) between two non-ionic components (the inorganic silica surface, I0 and the polyethylene oxide template, N0) by adding tetraethoxysilane to the non-ionic surfactant Brij®100, the latter previously dissolved in HCl 1 M. 50 mL water samples adjusted at pH= 3.5 were passed, at a flow rate of 5 mL/min, through a home-made cartridge containing 50 mg of MSU-1 sorbent, pre-conditioned with 5 mL of ultrapure water; then, the cartridge was washed with 5 mL of ultrapure water. Following elution with 5 mL of acetonitrile, the pesticides were determined by ultra performance liquid chromatography coupled to triple quadrupole-mass spectrometry. Two selected reaction monitoring transitions were monitored per compound, the most intense one being used for quantification and the second one for confirmation. Three points were used for identification, as established in the Directive 96/23/EC for LC-MS/MS analysis, which deals with confirmatory methods for organic residues and contaminants listed in the Group B (veterinary drugs and contaminants). Medium matrix effect (|20%|
Related Concept Videos
Phase Diagrams
States of Water
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
Phase Transitions
Network Covalent Solids
To break or to melt a covalent network solid, covalent bonds must be broken. Because covalent bonds are relatively strong, covalent network solids are typically...
Phase Transitions: Melting and Freezing
Metallic Solids
All metallic solids exhibit high thermal and electrical conductivity, metallic luster, and malleability....

