Related Experiment Video

Updated: Jan 26, 2026

Acute Myocardial Infarction in Rats
07:45

Acute Myocardial Infarction in Rats

Published on: February 16, 2011

54.5K

A hot lead on reducing infarct size

James C Blankenship1

  • 1Department of Cardiology 27-75, Geisinger Medical Center, Danville, Pennsylvania.

Catheterization and Cardiovascular Interventions : Official Journal of the Society for Cardiac Angiography & Interventions
|April 7, 2019
PubMed

Insights

Supersaturated oxygen (SSO2) therapy for ST-elevation myocardial infarction (STEMI) showed a low adverse event rate. This innovative treatment may help reduce heart attack damage in STEMI patients.

Area of Science:

  • Cardiology
  • Interventional Cardiology
  • Biomedical Engineering

Background:

  • ST-elevation myocardial infarction (STEMI) is a critical condition requiring prompt intervention.
  • Percutaneous coronary intervention (PCI) is a standard treatment for STEMI.
  • Reducing infarct size is a key goal in STEMI management.

More Related Videos

A Cryoinjury Model to Study Myocardial Infarction in the Mouse06:29

A Cryoinjury Model to Study Myocardial Infarction in the Mouse

Published on: September 19, 2019

10.0K
Histological Quantification of Chronic Myocardial Infarct in Rats09:45

Histological Quantification of Chronic Myocardial Infarct in Rats

Published on: December 11, 2016

15.4K

Related Concept Videos

Hot Weather Concreting01:20

Hot Weather Concreting

Concreting at elevated temperatures accelerates the hydration process, leading to quicker setting but potentially reducing the long-term strength of the concrete structure. Additionally, low air humidity fosters rapid moisture loss from the concrete, resulting in reduced workability, pronounced plastic shrinkage, and a higher likelihood of crazing.
Mitigating the heat increase in concrete can be economically achieved by shading aggregate stockpiles to prevent heating from solar radiation,...
313
Cell Size01:22

Cell Size

Cell sizes vary widely among and within organisms. Bacterial cells range between 1-10 micrometers (μm)and are considerably smaller than most eukaryotic cells. The smallest bacteria are 0.1 μm in diameter—about a thousand times smaller than eukaryotic cells, which typically range from 10-100 μm.
Surface Area
Cells can take in nutrients and water via diffusion through the plasma membrane itself or through specific channels in the membrane. The area of the membrane surrounding...
126.7K
Reducing Line Loss01:18

Reducing Line Loss

In a three-phase circuit, line loss is an indicator of energy dissipated as heat due to the resistance of transmission lines. To address this, incorporating transformers into the system—a step-up transformer at the source and a step-down transformer at the load—is a strategic solution. Two three-phase transformers are introduced to improve this.
With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss in...
372
Phase-lead and Phase-lag Controllers01:22

Phase-lead and Phase-lag Controllers

Understanding the working function of different types of controllers can be illustrated with practical analogies, such as adjusting a stereo's volume equalizer. Cranking up the bass involves a phase-lead controller, which functions as a high-pass filter, while increasing the treble uses a phase-lag controller, which acts as a low-pass filter. PD controllers, similar to high-pass filters, enhance the system's response to high-frequency components. PI controllers, akin to low-pass...
542
Masonry in Cold and Hot Weather Conditions01:21

Masonry in Cold and Hot Weather Conditions

In cold weather, masonry construction requires specific precautions to ensure mortar does not freeze before curing, as this can significantly weaken its strength and watertightness. Mortar temperature should be maintained between 60°F and 80°F to support proper hydration and curing. Below 40°F, mortar water must be heated, but should not exceed 120°F as high temperatures can reduce mortar's compressive and bond strength.
Other key practices include keeping masonry units...
341
Methods of reducing fever01:22

Methods of reducing fever

The signs and symptoms of fever include hot and dry skin, flushed face, thirst, muscle aches, anorexia, headache, tachycardia, tachypnea, and fatigue. Elevated body temperature is reduced using two methods: pharmacological and nonpharmacological. Proper identification and treatment of the root cause of a fever is of utmost importance.
Pharmacological Methods of Reducing Fever:
1.3K