Accumulation and Analysis of Cuprous Ions in a Copper Sulfate Plating Solution

Knowledge of the behavior of cuprous ions (monovalent copper ion: Cu(I)) in a copper sulfate plating bath is important for improving the plating process. We successfully developed a method to quantitatively and easily measure Cu(I) in a plating solution and used it for evaluation of the solution. In this paper, a quantitative absorption spectrum measurement and a time-resolved injection measurement of Cu(I) concentrations by a color reaction are described. This procedure is effective as a method to reproduce and elucidate the phenomenon occurring in the plating bath in the laboratory. First, the formation and accumulation process of Cu(I) in solution by electrolysis of a plating solution is shown. The amount of Cu(I) in the solution is increased by electrolysis at higher current values ​​than the usual plating process. For the determination of Cu(I), BCS (bathocuproinedisulfonic acid, disodium salt), a reagent that selectively reacts with Cu(I), is used. The concentration of Cu(I) can be calculated from the absorbance of the Cu(I)-BCS complex. Next, the time measurement of the color reaction is described. The color reaction curve of Cu(I) and BCS measured by the injection method can be decomposed into an instantaneous component and a delay component. By analysis of these components, the holding structure of Cu(I) can be clarified, and this information is important when predicting the quality of the plating film to be produced. This method is used to facilitate the evaluation of the plating bath in the production line.