Related Experiment Video

Updated: Jan 26, 2026

Crystallizing Membrane Proteins for Structure Determination using Lipidic Mesophases
22:00

Crystallizing Membrane Proteins for Structure Determination using Lipidic Mesophases

Published on: November 21, 2010

30.6K

Effect of Mixed Solvents on the Structure of Polyvinylidene Fluoride Flat Membrane in Thermally Induced Phase

Zhen Liu1, Qianqian Pan1, Jingni Gao1

  • 1State Key Laboratory of Separation Membranes and Membrane Processes, Tianjin Polytechnic University, Tianjin 300160, China; School of Materials Science and Engineering, Tianjin Polytechnic University, Tianjin 300387, China.

Journal of Nanoscience and Nanotechnology
|April 10, 2019
PubMed

More Related Videos

Unraveling Entropic Rate Acceleration Induced by Solvent Dynamics in Membrane Enzymes09:42

Unraveling Entropic Rate Acceleration Induced by Solvent Dynamics in Membrane Enzymes

Published on: January 16, 2016

9.4K
Preparation of Biopolymer Aerogels Using Green Solvents08:13

Preparation of Biopolymer Aerogels Using Green Solvents

Published on: July 4, 2016

18.3K

Related Concept Videos

Solvents01:12

Solvents

A solvent is a substance, most often a liquid, that can dissolve other substances. Here, the substance being dissolved is called a solute. When a solvent and a solute combine, they form a solution - a homogenous mixture of both the solvent and the solute. Water is a universal biological solvent. Its polar structure allows it to dissolve many other polar compounds. The ability of water to dissolve is governed by a balance between water molecules binding to each other and binding to the solute.
A...
70.2K
Titration in Nonaqueous Solvents01:16

Titration in Nonaqueous Solvents

Most acid-base titrations are performed in an aqueous medium. In aqueous titrations, water competes with weaker acids or bases for proton donation or acceptance, leading to ambiguous endpoints in the titration curve. Water also affects the partial ionization of weak acids or bases. For example, water accepts a proton from acetic acid to form hydronium and acetate ions. The hydronium ion formed is a stronger acid than acetic acid, and the acetate ion is a stronger base than water. As a result,...
1.4K
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
14.8K
Phase Diagrams02:39

Phase Diagrams

A phase diagram combines plots of pressure versus temperature for the liquid-gas, solid-liquid, and solid-gas phase-transition equilibria of a substance. These diagrams indicate the physical states that exist under specific conditions of pressure and temperature and also provide the pressure dependence of the phase-transition temperatures (melting points, sublimation points, boiling points). Regions or areas labeled solid, liquid, and gas represent single phases, while lines or curves represent...
49.9K
Flat Belts: Problem Solving01:28

Flat Belts: Problem Solving

Flat belts are crucial in many industrial applications as they help transmit power from one pulley to another. The concept of forces and moments is used to determine the maximum moment on a pulley. For instance, consider a flat belt that wraps around two pulleys, A and B, with radii of 30 cm and 10 cm, respectively. The angle between the belt and the horizontal is 20 degrees at the pulleys. As pulley B rotates clockwise and drives pulley A, tension T2 is caused at one end of the belt, while...
802
Ionic Crystal Structures02:42

Ionic Crystal Structures

Ionic crystals consist of two or more different kinds of ions that usually have different sizes. The packing of these ions into a crystal structure is more complex than the packing of metal atoms that are the same size.
Most monatomic ions behave as charged spheres, and their attraction for ions of opposite charge is the same in every direction. Consequently, stable structures for ionic compounds result (1) when ions of one charge are surrounded by as many ions as possible of the opposite...
16.9K