Related Experiment Video
Updated: Jan 26, 2026

Transtubular Endoscopic Posterolateral Decompression for L5-S1 Lumbar Lateral Disc Herniation
Published on: October 14, 2022
Changes in Shear Modulus of the Lumbar Multifidus Muscle During Different Body Positions
Seyedali Sadeghi1, Kevin Quinlan2, Kirsten E Eilertson3
1Department of Mechanical andNuclear Engineering,College of Engineering,The Pennsylvania State University,State College, PA 16802e-mail: sus653@psu.edu.
Abstract:
Multifidus function is important for active stabilization of the spine, but it can be compromised in patients with chronic low back pain and other spine pathologies. Force production and strength of back muscles are often evaluated using isometric or isokinetic tests, which lack the ability to quantify multifidi contribution independent of the erector spinae and adjacent hip musculature. The objective of this study is to evaluate localized force production capability in multifidus muscle using ultrasound shear wave elastography (SWE) in healthy individuals. Three different body positions were considered: lying prone, sitting up, and sitting up with the right arm lifted. These positions were chosen to progressively increase multifidus contraction and to minimize body motion during measurements. Shear modulus was measured at the superficial and deeper layers of the multifidus. Repeatability and possible sources of error of the shear modulus measurements were analyzed. Multifidus shear modulus (median (interquartile range)) increased from prone, i.e., 16.15 (6.69) kPa, to sitting up, i.e., 27.28 (15.72) kPa, to sitting up with the right arm lifted position, i.e., 45.02 (25.27) kPa. Multifidi shear modulus in the deeper layer of the multifidi was lower than the superficial layer, suggesting lower muscle contraction. Intraclass correlation coefficients (ICCs) for evaluation of shear modulus by muscle layer were found to be excellent (ICC = 0.76-0.80). Results suggest that the proposed protocol could quantify local changes in spinal muscle function in healthy adults; further research in patients with spine pathology is warranted.
Related Concept Videos
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity
Bulk Modulus
Fineness Modulus
Consider performing sieve analysis on sand through a set of ASTM sieves. The weight of aggregate retained in each sieve and pan placed at the bottom is recorded, as given in Column B of Table 1.
To determine the fineness modulus of...
Strain and Elastic Modulus
Dynamic Modulus of Elasticity of Concrete
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by a...
Shearing Stress
The average shearing stress can be calculated by dividing the shear by the area of the cross-section.

