5000 h Multi-Factor Accelerated Aging Test of FRP Made Transmission Tower: Characterization, Thermal Decomposition
Jianwei Shao1, Junhua Wang2, Mengjiao Long3
1School of Electrical Engineering, Wuhan University, Wuhan 430072, China. hitwhshao@whu.edu.cn.
Abstract:
Three kinds of fiber reinforced plastic (FRP) composites, including modified polyurethane resin (LGD), epoxy resin (E44) and modified unsaturated polyester resin (D33) glass-fiber reinforced plastics, were subjected to a 5000 h multi-factor accelerated aging test according to the power industry standard. To examine aging resistance and thermal stability of transmission towers made by these three composites, relevant bending properties, thermogravimetric analysis (TGA) and derivative thermogravimetry (DTG), activation energy, as well as microscopic morphology were revealed. The results showed that for these composites, bending modulus retention rates were higher than 94% under the aging test and that of the LGD was highest. Additionally, the onset degradation temperature, temperature at maximum rate of weight loss and T5% reduced at 5000 h, with D33 having highest value and lowest decline rate. The activation energy was calculated with the Bagchi, Coats-Redfern and Broido method, respectively. Although the activation energy of all composites decreased after test, the D33, LGD materials had the highest activation energy which enjoys slight decline. Analysis of the whole experimental results suggested that D33 and LGD composites have good aging resistance, whose basic performance could still perform well after 5000 h aging test, so they can be used to composite towers and applied to engineering practice.
Related Concept Videos
02:17Synthesis and Decomposition Reactions
02:05SN1 Reaction: Kinetics
However, Sir Christopher Ingold and Edward D. Hughes, who studied the kinetics of various nucleophilic substitution reactions, noticed that a tertiary alkyl halide does undergo a nucleophilic substitution reaction in the presence of a weak nucleophile. While studying the substitution...
02:14SN2 Reaction: Kinetics
In a chemical reaction, a relationship exists between the concentration of reactants and the rate at which the reaction proceeds. The study to measure this relationship is known as the kinetics of a chemical reaction. Kinetic studies are used to deduce the rate law of a chemical reaction, which provides information about the species involved during the transition state of the rate-determining step. Thus, kinetic studies help to derive the mechanism of a...
02:55Temperature Dependence on Reaction Rate
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...
01:17Thermal Electrocyclic Reactions: Stereochemistry
Selection Rules: Thermal Activation
Conjugated systems containing an even number of π-electron pairs undergo a conrotatory ring closure. For example, thermal electrocyclization of (2E,4E)-2,4-hexadiene, a conjugated diene containing two π-electron pairs, gives trans-3,4-dimethylcyclobutene.
01:16Thermal Sigmatropic Reactions: Overview
Sigmatropic shifts are classified based on an order term [i, j ], where i and j indicate the number of atoms across which each end of the σ bond migrates. Below are examples of a [3,3] sigmatropic shift in 1,5-hexadiene, referred...