Quantification of Equine Sacral and Iliac Motion During Application of Manual Forces and Comparison Between Motion Capture With Skin-Mounted and Bone-Fixated Sensors

Diagnosis of sacroiliac dysfunction in horses includes manual motion palpation of the equine ilium and sacrum. Motion of the ilium and sacrum during manual force application to the equine pelvis has been measured previously in vitro. The aim of this study was to measure the amount and direction of motion in vivo, including comparison of bone-fixated and skin-mounted inertial sensors. Sensors were skin-mounted over tuber sacrale (TS) and third sacral spinous process of six Thoroughbred horses and later attached via Steinmann pins inserted into the same bony landmarks. Orientations of each TS and sacrum were recorded by one investigator during six trials of manual force applied to the pelvis, inducing cranial, caudal, and oblique rotations. Mean values were reported in Euler angles for the three orthogonal planes lateral bending, flexion-extension (FE), and axial rotation (AR). Differences between skin- and bone-fixated markers were determined with significance set at P < .05. The largest mean values recorded during rotations applied to the pelvises were for FE, (2.08° ± 0.35°) with bone-fixated sensors. AR gave the largest values recorded with skin mountings (1.70° ± 0.48°). There was a poor correlation between skin-mounted and bone-fixated markers with AR being the orthogonal plane in which results from skin mounting were closest to results from bone-fixated sensors Bony kinematics during external movement applied to the pelvis cannot be predicted from skin-mounted sensors, due to differences between skin- and bone-mounted sensors.