Related Experiment Video
Updated: Jan 26, 2026

Sub-nanometer Resolution Imaging with Amplitude-modulation Atomic Force Microscopy in Liquid
Published on: December 20, 2016
Comparison of torsional amplitudes between emmetropes and myopes using after-image slides
Antony Arokiadass Baskaran1, Tanuja Britto1, Sundaresan Rajkumar1
1Department of Pediatric Ophthalmology, Institute of Ophthalmology, Joseph Eye Hospital, Trichy-1, Tamil Nadu, India.
Purpose:
To describe the influence of corrected refractive error on measured torsional fusional amplitudes (TA) by comparing the TA between emmetropes and spectacle corrected myopes, using the after-image slides of the synoptophore, as targets.
Methods:
Fifty emmetropes (Group I) and 50 myopes (Group II) with best-corrected acuity of 6/6 in each eye were included in the study. Near point of convergence (NPC), near point of accommodation (NPA), and horizontal fusional amplitudes (HFA) were assessed in all the subjects. After-image slides, both horizontally aligned, were used as targets (without the bright flashes). One of the slides was rotated inwards, till cyclo-diplopia was reported by the subject; the procedure was repeated with the slide rotated outwards. The sum of the two readings was taken as TA. NPC, NPA, HFA, and TA were analyzed.
Results:
There was no significant difference in the NPC, NPA, and HFA between the two groups. The emmetropic subjects had significantly better torsional amplitude (8.4 ± 1.4 degrees) compared to myopes (7.7 ± 1.5 degrees, P = 0.03). We postulate that this difference may be due to perceived image minification, which brings the edges of retinal image of the targets closer to the fovea, thus rendering the myopes lesser tolerant to cyclodiplopia than emmetropes.
Conclusion:
Refractive error, corrected with spectacles, influences the measured TA. Myopic subjects have lesser torsional fusional amplitude than emmetropes.
Related Concept Videos
Torsion of Noncircular Members
Torsional Pendulum
As long as the rigid body's angular displacement is small, its oscillation can be modeled as a linear angular oscillation. The amplitude of the oscillation is an angle. The role of mass is played...
Bending and Torsional Moments
The reaction developed in a structural element when subjected to an external force causes the element to bend. When a structural element bends upwards, it creates compressive normal forces on the top and tensile normal forces on the bottom, resulting in a couple that determines the bending...
Pulse amplitude and quality
A weak or absent pulse may indicate reduced cardiac output or poor left ventricular contraction, which can be signs of cardiovascular dysfunction or...
The Sense of Self: Reflected Self-Appraisal and Social Comparison
Design Example: Designing Water Slide
Bernoulli's principle determines the water's velocity along the slide....

