Fate and transport of urea-N in a rain-fed ridge-furrow crop system with plastic mulch

Sheng Guo1, Rui Jiang1,2, Hongchao Qu1

  • 1Key Laboratory of Plant Nutrition and the Agri-environment in Northwest China, Ministry of Agriculture, College of Natural Resources and Environment, Northwest A&F University, Yangling, 712100, China.

Soil & Tillage Research
|April 23, 2019
PubMed

Related Concept Videos

Urea Cycle01:23

Urea Cycle

The urea cycle describes how liver cells convert ammonia to urea. Ammonia is a toxic waste product of protein catabolism. Land animals must convert ammonia into the less toxic urea which can be safely eliminated by the kidneys through urine. Marine animals excrete ammonia directly, and the surrounding water dilutes the ammonia to safe levels.
50.0K
Fates of Pyruvate01:20

Fates of Pyruvate

Pyruvate is the end product of glycolysis, where glucose is oxidized to pyruvate, simultaneously reducing NAD+ to NADH. Two molecules of ATP are also produced by substrate-level phosphorylation.
In aerobic organisms, pyruvate is metabolized via the citric acid cycle to produce reduced coenzymes NADH and FADH2. These coenzymes are then oxidized in the electron transport chain to produce ATP and, in the process, regenerate the NAD+ and FAD. As seen in some cell types and organisms, fermentation...
10.5K
Plasticizers01:31

Plasticizers

Water-reducers, or plasticizers, are chemical admixtures used in concrete to improve strength and workability. These additives reduce the water-cement ratio without compromising workability, lower the cement content while maintaining the same workability, or increase workability to assist concrete placement in inaccessible areas.
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
355
Plasticity00:58

Plasticity

Plasticity is the property where an object loses its elasticity and undergoes irreversible deformation, even after the deformation forces are eliminated. If a material deforms irreversibly without increasing stress or load, then this is called ideal plasticity. For example, when a force is applied to an aluminum rod, it changes its shape, but it does not return to its original shape once the force is removed. Plastic deformation or ductility is thus a permanent deformation or change in the...
3.0K
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
539
Plastic Deformations01:14

Plastic Deformations

It is essential to understand how structural members behave under plastic deformation when the bending stress exceeds the material's yield strength. This state of deformation permanently alters the shape of the member, in contrast to the linear elastic behavior observed before yielding. The strain at any point in the member is expressed in terms of maximum strain. Notably, the neutral axis, which coincides with the centroid during elastic bending, shifts away from the centroid under plastic...
412