Mechanical Behaviour of ABS-Fused Filament Fabrication Compounds under Impact Tensile Loadings

In the Fused Filament Fabrication (FFF) process, the part is built as a layer-by-layer deposition of a feedstock filament material. The continuous improvements of the FFF have changed the main purpose of this technique from rapid prototyping to a rapid manufacturing method. Then, it is fundamental to determine the material properties of FFF parts as a function of the service load. The impact loads and, in particular, a high strain rates tensile impact can be a critical issue in FFF part and, in general, for plastic materials. The aim of the present work is to characterise the mechanical behaviour of FFF parts under tensile impact loads. To this purpose, three different orientations (i.e., 0°, 45° and 90°) both single- and multilayer specimens, have been printed. Finally, the influence of the impact speed on the mechanical behaviour has also been tested under three different values of speed (3.78 m/s, 3.02 m/s and 2.67 m/s). The results show that the FFF parts are influenced by the raster orientation, confirming the orthotropic behaviour also under dynamic loads, while the variation of impact speed, on peak force and absorbed energy, is limited.