Related Experiment Video
Updated: Jan 25, 2026

Whole-Mount Immunofluorescence Staining, Confocal Imaging and 3D Reconstruction of the Sinoatrial and Atrioventricular Node in the Mouse
Published on: December 22, 2020
Pipe-3D: A Pipeline Based on Immunofluorescence, 3D Confocal Imaging, Reconstructions, and Morphometry for Biliary
Amruta Damle-Vartak1, Brigitte Begher-Tibbe1, Georgia Gunther1
1Department of Systems Toxicology, Leibniz Research Centre for Working Environment and Human Factors (IfADo) at TU Dortmund, Dortmund, Germany.
Abstract:
Cholestasis, the impairment of bile flux out of the liver, is a common complication of many pathological liver disorders, such as cholangiopathies, primary biliary sclerosis, and primary biliary cirrhosis. Besides accumulation of bile acids in the liver and blood, it leads to a proliferative response of the biliary tree termed as a ductular reaction. The ductular reaction is characterized by enhanced proliferation of cholangiocytes, which form the epithelial lining of bile ducts. This strong reaction of the biliary tree has been reported to generate a source of progenitor cells that can differentiate to hepatocytes or cholangiocytes during regeneration. On the other hand, it can cause periportal fibrosis eventually progressing to cirrhosis and death. In 2D histology, this leads to the appearance of an increased number of duct lumina per area of tissue. Yet, the biliary tree is a 3D vstructure and the appearance of lumina in thin slices may be explained by the appearance of novel ducts or by ramification or convolution of existing ducts in 3D. In many such aspects, traditional 2D histology on thin slices limits our understanding of the response of the biliary tree. A comprehensive understanding of architecture remodeling of the biliary network in cholestasis depends on robust 3D sample preparation and analysis methods. To that end, we describe pipe-3D, a processing and analysis pipeline visualization based on immunofluorescence, confocal imaging, surface reconstructions, and automated morphometry of the biliary network in 3D at subcellular resolution. This pipeline has been used to discover extensive remodeling of interlobular bile ducts in cholestasis, wherein elongation, branching, and looping create a dense ductular mesh around the portal vein branch. Surface reconstructions generated by Pipe-3D from confocal data also show an approximately fivefold enhancement of the luminal duct surface through corrugation of the epithelial lamina, which may increase bile reabsorption and alleviate cholestasis. The response of interlobular ducts in cholestasis was shown to be in sharp contrast to that of large bile ducts, de novo duct formation during embryogenesis. It is also distinct from ductular response in other models of hepatic injury such as choline-deficient, ethionine-supplemented diet, where parenchymal tissue invasion by ducts and their branches is observed. Pipe-3D is applicable to any model of liver injury, and optionally integrates tissue clearing techniques for 3D analysis of thick (>500 μm) tissue sections.
More Related Videos
Related Concept Videos
General Characteristics of Pipe Flow I
The classification of fluid...
Major Losses in Pipes
Fluid flow can be classified as laminar or turbulent, primarily based on the Reynolds number. This dimensionless number reflects the relative influence of inertial to viscous...
Minor Losses in Pipes
Valves play a significant role in generating minor losses by obstructing or redirecting the fluid flow. When a valve is closed or partially closed, it restricts the flow...
Single Pipe Systems
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are...
Multiple Pipe Systems
Series Configuration
In a series configuration, fluid flows sequentially from one pipe...
Pipe Flowrate Measurement
The orifice meter is a simple,...

