Total knee arthroplasty after Hauser procedure: beware of the patellar tendon!

Zachary C Lum1, Mauro Giordani1, John P Meehan1

  • 1Orthopaedic Surgery Department, University of California: Davis Medical Center, Sacramento, CA, USA.

Arthroplasty Today
|April 26, 2019
PubMed

Preoperative planning is a fundamental element in total knee arthroplasty (TKA). A previous surgery that must be recognized and identified preoperatively is the Hauser procedure, a posteromedialization of the tibial tubercle for recurrent patellar instability. Here, we describe 2 case reports in patients with previous Hauser surgeries. The first TKA surgery was complicated from a standard medial peripatellar approach resulting in complete transection of the patellar tendon during standard arthrotomy. The tendon was repaired, and the arthroplasty was aborted. For the second case, correct preoperative identification of the Hauser procedure was performed. The second TKA surgery was performed using a lateral peripatellar arthrotomy with excellent exposure, resulting in a successful operation. Here, we highlight the importance of an accurate history, physical and radiographic examination, and the recommendation of an alternative TKA approach to help avoid the serious intraoperative complication of a patellar tendon laceration.

Related Concept Videos

Knee Joint01:23

Knee Joint

The knee joint is the most complicated joint in the body. It consists of three articulations– two tibiofemoral and one patellofemoral. As is characteristic of synovial joints, the knee joint has a thin articular capsule that partially surrounds this joint cavity. Additionally, several ligaments, muscles, and cartilaginous structures support the movement of the knee.
A total of seven ligaments support the knee joint. The patellar ligament, which is also attached to the quadriceps femoris...
3.1K
Total Voids in Concrete01:12

Total Voids in Concrete

Total voids in concrete encompass gel water volume, capillary pores, and entrapped air. Gel water (retained within the cement hydration products) and physically entrapped or adsorbed water are significant for the hydration process. For complete hydration, it's estimated that the space needed for the products of a cubic centimeter of cement doubles. Capillary pores constitute the unoccupied space within the hydrated cement paste, with their size largely influenced by the water-to-cement...
473
Total Internal Reflection Fluorescence Microscopy01:05

Total Internal Reflection Fluorescence Microscopy

Total internal reflection fluorescence microscopy or TIRF is an advanced microscopic technique used to visualize fluorophores in samples close to a solid surface with a higher refractive index, such as a glass coverslip. TIRF only allows fluorophores in proximity to the solid surface to be excited. When light from a medium with a lower refractive index (such as air) hits the glass coverslip at a critical angle, the light undergoes total internal reflection stead of passing through the glass.
11.1K
Static, Stagnation, Dynamic and Total Pressure01:24

Static, Stagnation, Dynamic and Total Pressure

The concept of static, stagnation, dynamic, and total pressure is fundamental in fluid dynamics, often explained using Bernoulli's equation:
1.5K
Blind Procedures02:07

Blind Procedures

Ideally, the people who observe and record the children’s behavior are unaware of who was assigned to the experimental or control group, in order to control for experimenter bias. Experimenter bias refers to the possibility that a researcher’s expectations might skew the results of the study. Remember, conducting an experiment requires a lot of planning, and the people involved in the research project have a vested interest in supporting their hypotheses. If the observers knew which...
13.4K
Handwashing II: Pre-procedure and Initial Procedure Steps01:19

Handwashing II: Pre-procedure and Initial Procedure Steps

The pre-procedure steps of handwashing include removing jewelry and rolling up sleeves. However, many organizations allow staff to wear wedding rings.
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury.  The nails must be short and clean, without nail...
1.5K