Related Experiment Video
Updated: Jan 25, 2026
Author Spotlight: Extraction of Guinea Pig Round Window Membrane to Facilitate Inner Ear Drug Delivery Research
Published on: February 23, 2024
Round Window Membrane Motion Induced by Bone Conduction Stimulation at Different Excitation Sites: Methodology of
Monika Kwacz1, Kazimierz Niemczyk2, Jarosław Wysocki3
1Institute of Micromechanics and Photonics, Warsaw University of Technology, Warsaw, Poland.
Objectives:
The aim of this study was to investigate the following: (1) the vibration pattern of the round window (RW) membrane in human cadavers during air (AC) and bone conduction (BC) stimulation at different excitation sites; (2) the effect of the stimulation on the fluid volume displacement (VD) at the RW and compare the VD between BC and AC stimulation procedures; (3) the effectiveness of cochlear stimulation by the bone implant at different excitation sites.
Design:
The RW membrane vibrations were measured by using a commercial scanning laser Doppler vibrometer. The RW vibration amplitude was recorded at 69 measurement points evenly distributed in the measurement field covering the entire surface of the RW membrane and a part of the surrounding bony surface. RW vibration was induced first with AC and then with BC stimulation through an implant positioned at two sites. The first site was on the skull surface at the squamous part of the temporal bone (implant no. 1), a place typical for bone-anchored hearing aids. The second site was close to the cochlea at the bone forming the ampulla of the lateral semicircular canal (implant no. 2). The displacement amplitude (dP) of the point P on the promontory was determined and used to calculate the relative displacement (drRW) of points on the RW membrane, drRW = dRW - dP. VD parameter was used to analyze the effectiveness of cochlear stimulation by the bone implant screwed at different excitation sites.
Results:
RW membrane displacement amplitude of the central part of the RW was similar for AC and BC implant no. 1 stimulation, and for BC implant no. 2 much larger for frequency range >1 kHz. BC implant no. 2 causes a larger displacement amplitude of peripheral parts of the RW and the promontory than AC and BC implant no. 1, and BC implant no. 1 causes larger than AC stimulation. The effect of BC stimulation exceeds that of AC with identical intensity, and that the closer BC stimulation to the otic capsule, the more effective this stimulation is. A significant decrease in the value of VD at the RW is observed for frequencies >2 kHz for both AC and BC stimulation with BC at both locations of the titanium implant placement. For frequencies >1 kHz, BC implant no. 2 leads to a significantly larger VD at the RW compared to BC implant no. 1. Thus, the closer to the otic capsule the BC stimulation is located, the more effective it is.
Conclusions:
Experimental conditions allow for an effective acoustic stimulation of the inner ear by an implant screwed to the osseous otic capsule. The mechanical effect of BC stimulation with a titanium implant placed in the bone of the ampulla of the lateral semicircular canal significantly exceeds the effect of an identical stimulation with an implant placed in the temporal squama at a conventional site for an implant anchored in the bone. The developed research method requires the implementation on a larger number of temporal bones in order to obtain data concerning interindividual variability of the observed mechanical phenomena.
Related Concept Videos
01:14Temperature Measurement Sites
Oral: When assessing oral temperature, the thermometer tip should be placed under the tongue in the posterior sublingual pocket. It offers accurate readings and can be...
01:24Absolute Motion Analysis- General Plane Motion
As the drone's propellers rotate, an upward force is generated that counteracts the force of gravity, enabling the drone to lift off from the ground. This initial movement of the drone is along a straight path, representing a form of translational motion. In this phase, every point on the...
01:49Conserved Binding Sites
Binding sites are often located in large pockets, and if their location on a protein’s surface is unknown, it can be predicted using various approaches. The energetic method computationally...
01:10Relative Motion Analysis - Acceleration
01:24Relative Motion Analysis - Velocity
When an external force is exerted, it sets the crank into a rotational movement. This, in turn, instigates the motion of the connecting rod, leading to what is referred to as a general plane motion. This process involves two key points - point A on the connecting rod...
02:40Ligand Binding Sites
Protein-ligand interactions are quite specific; even though numerous potential ligands surround a cellular protein at any given time, only a particular ligand can bind to that protein. Moreover, a ligand binds only to a dedicated area on the surface of the protein, known as the...