Related Experiment Video
Updated: Jan 25, 2026

An In Vitro Approach to Photodynamic Therapy
Published on: August 17, 2018
Pheophytin Derived Near-Infrared-Light Responsive Carbon Dot Assembly as a New Phototheranotic Agent for Bioimaging
Yongmei Wen1,2, Qingyan Jia3, Fuchun Nan1,2
1Key Laboratory of Photochemical Conversion and Optoelectronic Materials and City U-CAS Joint Laboratory of Functional Materials and Devices, Technical Institute of Physics and Chemistry, Chinese Academy of Sciences, Zhongguancun east road 29#, Beijing, 100190, P. R. China.
Abstract:
Carbon dots (CDs), a kind of phototheranostic agent with the capability of simultaneous bioimaging and phototherapy [i.e., photodynamic therapy (PDT) or photothermal therapy (PTT)], have received considerable attention because of their remarkable properties, including flexibility for surface modification, high biocompatibility, low toxicity and photo-induced activity for malignant tumor cells. Among numerous carbon sources, it has been found that natural biomass are good candidates for the preparation of CD phototheranostic agents. In this study, pheophytin, a type of Mg-free chlorophyll derivative and also a natural product with low toxicity, was used as a raw carbon source for the synthesis of CDs by using a microwave method. The obtained hydrophobic CDs exhibited a maximum near-infrared (NIR) emission peak at approximately 680 nm, and high singlet oxygen (1 O2 ) generation with a quantum yield of 0.62. The self-assembled CDs from the as-prepared CDs with DSPE-mPEG2000 retained efficient 1 O2 generation. The obtained carbon dot assembly was not only an efficient fluorescence (FL) imaging agent but also a smart PDT agent. Our studies indicated that the obtained hydrophilic CD assembly holds great potential as a new phototheranostic agent for cancer therapy. This work provides a new route for synthesis of CDs and proposes a readily available candidate for tumor treatment.
More Related Videos
Related Concept Videos
Photoreceptors and Plant Responses to Light
The Carbon Cycle
Carbon Skeletons
Dot Product
In engineering, the dot product of any two vectors is the product of the magnitudes of the vectors and the cosine of the angle between them. It is denoted by a dot symbol between the two vectors.
Consider a vehicle pulling an object along the ground using a rope. If the rope makes an angle with the horizontal axis, the work done can be calculated using the dot product of the force applied and the object's displacement.
The dot...
Dot Product: Problem Solving
Identify the problem: Start by reading the problem and...
Carbonation Shrinkage
The concrete's permeability is slightly reduced as calcium carbonate produced during the reaction fills its pores. Furthermore, its strength is slightly enhanced as the water released during the reaction...

