Related Experiment Video
Updated: Jan 25, 2026

Writing Bragg Gratings in Multicore Fibers
Published on: April 20, 2016
Low-cost optical fiber temperature-sensing system employing optical transceivers for Ethernet and long-period fiber
Abstract:
Optical fiber sensors have numerous advantages over electrical sensors. However, in some cases, sensing systems based on optical fiber sensors are inferior to electrical sensors in terms of cost because expensive instruments are required. Therefore, cost-effective options must be developed. Here, inexpensive optical transceivers (OTRs) for Ethernet were used instead of a broadband light source and optical spectrum analyzer, and a CO2 laser-induced long-period fiber grating (LPFG) was used as a temperature sensor. The sensing system was implemented introducing OTRs and LPFG in an experimental internet protocol (IP) over Ethernet. The results showed that a low-cost sensing system can estimate the ambient temperature of the LPFG based on the no-reply rate for the internet control message protocol echo request. Regarding the sensing performance, the measurable range was ∼100°C with ±4.5°C errors.
Related Concept Videos
Classification of Skeletal Muscle Fibers
Slow-Twitch Muscle Fibers
Slow oxidative, muscle fibers appear red due to large numbers of capillaries and high levels of...
Fiber Reinforced Concrete
Types of Skeletal Muscle Fibers
Fast-twitch fibers
Fast-twitch fibers, or Type II fibers, are designed for quick, powerful bursts of speed and strength. They reach peak tension within approximately 0.01 seconds following stimulation. Characterized by a large diameter and densely packed myofibrils, these fibers contain...
Formation of Muscle Fibers from Myoblasts
Muscle progenitor cells (MPCs) are formed from the myotomes. MPCs express genes that encode the transcription factors Pax3 and Pax7. Along with Pax 3/7, other transcription...
Connective Tissue Fibers and Ground Substance
Local Anesthetics: Differential Sensitivity of Nerve Fibers

