Lessons from London and Berlin: Designing A Scalable Gene Therapy Approach for HIV Cure

Gene therapy is a technique where a gene is inserted into a person’s cells to prevent or treat a serious disease. The added gene may be a healthy version of the gene that is mutated in the patient, or it could be a different gene that inactivates or compensates for the patient’s disease-causing gene. For example, in patients with severe combined immunodeficiency (SCID) due to a mutation in the gene for the enzyme adenosine deaminase, a functioning version of the gene can be...

The hydration of cement takes place within the water-filled capillary pores. However, environmental elements can disrupt this process by evaporating water from the concrete surfaces. Sealed concrete with a water-cement ratio below 0.5 experiences self-desiccation, leading to water loss. The water loss in concrete is mitigated by curing. This technique involves keeping the concrete saturated to maintain the necessary temperature and moisture conditions, to optimally fill the spaces in the cement...

Concrete members with a small surface-to-volume ratio are cured by oiling and moistening the forms before casting the concrete member. These forms can be left in place for a prolonged period to prevent moisture loss, and can be wetted if made of a material suitable for wetting. If the forms are removed early, the concrete member is moistened and covered with polythene sheets to maintain moisture. For large horizontal concrete surfaces exposed to dry weather, a temporary covering is suspended...

Designing a dosage regimen, which refers to the manner of drug administration, is a complex process involving the selection of drug dose, route, and frequency. This process is underpinned by pharmacokinetic parameters derived from tests and population averages. These parameters are then tailored to patient-specific variables such as diagnosis, demographics, and allergy status. Once therapy commences, therapeutic response monitoring is critical and achieved through clinical and physical...

Accelerating concrete curing is achieved by applying heat and additional moisture. This process accelerates the hydration of the cement, resulting in an earlier strength gain in the concrete. Steam curing is a method wherein the concrete products are either transported through a chamber on a conveyor belt or encased in plastic, allowing steam at atmospheric pressure to circulate freely around them. This process begins with a phase of moist curing that typically lasts between 3 to 5 hours, after...

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between...