Related Experiment Video
Updated: Jan 25, 2026

Luminescence Lifetime Imaging of O2 with a Frequency-Domain-Based Camera System
Published on: December 16, 2019
Observation of early strut coverage after polymer-free biolimus-A9 coated stent by optical frequency domain imaging
Yusuke Ochiumi1, Yoriyasu Suzuki1
1Department of Cardiology, Nagoya Heart Center, Aichi, Japan.
Abstract:
An 80-year-old male patient with an acute myocardial infarction in the mid left anterior descending artery was treated with a BioFreedom stent (2.5 × 24 mm) (Biosensors Inc., Newport Beach, CA, USA). Thirty days post procedure, the patient was re-admitted with chest pain. A significant coronary artery stenosis in the mid left anterior descending artery more progressive than the previous one (not involving proximal stent-edge) was treated with percutaneous coronary intervention. Following this, optical frequency domain imaging of the BioFreedom stent revealed a fully expanded stent with complete stent apposition in its entire length and strut coverage with neointimal hyperplasia. <Learning objective: For patients with high bleeding risk, BioFreedom stent (Biosensors Inc., Newport Beach, CA, USA) may be considered a sufficiently effective device with shortened duration of dual antiplatelet therapy.>.
Related Concept Videos
Linear Approximation in Frequency Domain
In contrast, nonlinear systems do not inherently possess these properties. However, for small deviations around an operating point, a nonlinear system can often be approximated as linear....
Frequency-Domain Interpretation of PD Control
The proportional control gain, combined with the...
Time and frequency -Domain Interpretation of PI Control
Acting as a low-pass filter, the PI controller slows the system's response and extends settling times. This requires...
Time and frequency -Domain Interpretation of Phase-lead Control
The design of phase-lead control involves the strategic placement of poles and zeros to balance steady-state error and system...
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any...
Polymers

