Fuel production from waste polystyrene via pyrolysis: Kinetics and products distribution
Jan Nisar1, Ghulam Ali1, Afzal Shah2
1National Center of Excellence in Physical Chemistry, University of Peshawar, Peshawar 25120, Pakistan.
Abstract:
In the present study polystyrene waste (PS) was collected from a drop off site in a local market and pyrolyzed at heating rates of 5, 10, 15 and 20 °C/min and temperature range 40-600 °C under nitrogen condition. The apparent activation energy (Ea) and pre-exponential factor (A) were determined using 6 different kinetic methods. Activation energy and pre-exponential factor were found in the range of 82.3 - 202.8 kJmol-1 and 3.5 × 106-7.6 × 1014 min-1 respectively. The results demonstrated that the calculated values of Ea and A vary with fraction of conversion, heating rates and the applied model. Moreover, pyrolysis of waste polystyrene was carried out in an indigenously manufactured furnace at temperatures ranging from 340 to 420 °C. The composition of liquid and gaseous fractions was determined using gas chromatography-mass spectrometry. Temperature and reaction time were optimized and the results revealed that temperature of 410 °C and exposure time of 70 min are the best conditions for maximum fuel oil production. Methane and ethane were found as the main products in the gas phase constituting about 82% of the gaseous fraction. The liquid products composed of broad range of C2 - C15 hydrocarbons depending on the pyrolytic parameters. A comparison of the composition of pyrolysis oil with standard parameters of diesel, gasoline and kerosene oil suggested that pyrolysis oil from polystyrene waste holds great promise for replacing fuel oil.
Related Concept Videos
01:11Scalar Product (Dot Product)
The scalar product of two vectors is obtained by multiplying...
01:17Vector Product (Cross Product)
Consider the cross product of two vectors. Imagine rotating the first vector about...
03:12Batteries and Fuel Cells
03:07Kinetic Molecular Theory: Molecular Velocities, Temperature, and Kinetic Energy
01:21Wood Products
Glue-laminated wood, often referred to as glulam, combines multiple smaller pieces of dimensional lumber using adhesives to form a single, larger piece. Cross-laminated timber consists...
01:29Dot Product
In engineering, the dot product of any two vectors is the product of the magnitudes of the vectors and the cosine of the angle between them. It is denoted by a dot symbol between the two vectors.
Consider a vehicle pulling an object along the ground using a rope. If the rope makes an angle with the horizontal axis, the work done can be calculated using the dot product of the force applied and the object's displacement.
The dot...