Synchrotron tomography of intervertebral disc deformation quantified by digital volume correlation reveals

C M Disney1, A Eckersley2, J C McConnell2

  • 1Centre for Doctoral Training in Regenerative Medicine, The University of Manchester, Manchester, UK; Division of Cell Matrix Biology and Regenerative Medicine, The University of Manchester, Manchester, UK.

Acta Biomaterialia
|May 15, 2019
PubMed
Abstract

Related Concept Videos

Correlations02:20

Correlations

Correlation means that there is a relationship between two or more variables (such as ice cream consumption and crime), but this relationship does not necessarily imply cause and effect. When two variables are correlated, it simply means that as one variable changes, so does the other. We can measure correlation by calculating a statistic known as a correlation coefficient. A correlation coefficient is a number from -1 to +1 that indicates the strength and direction of the relationship between...
35.8K
Correlation and Causation01:27

Correlation and Causation

Statistical tests can calculate whether there is a relationship, or correlation, between independent and dependent variables. An indirect relationship of the variables signifies a correlation, while a direct relationship shows causation. If it is determined that no connection exists between the variables, then the correlation is a coincidence.
Correlation versus Causation
If the dependent variable increases or decreases when the independent variable increases, there is a positive or negative...
42.4K
Plastic Deformations01:19

Plastic Deformations

Plastic deformation represents a fundamental concept in materials science, which explains the irreversible change in the shape of a material when it experiences stress beyond its elastic capability. This phenomenon is important in structural engineering, especially in designing and analyzing cantilever beams—structures that are securely fixed at one end and bear loads at the opposite end. When these beams are subjected to loads within their elastic range, they will return to their...
442
Plastic Deformations01:14

Plastic Deformations

It is essential to understand how structural members behave under plastic deformation when the bending stress exceeds the material's yield strength. This state of deformation permanently alters the shape of the member, in contrast to the linear elastic behavior observed before yielding. The strain at any point in the member is expressed in terms of maximum strain. Notably, the neutral axis, which coincides with the centroid during elastic bending, shifts away from the centroid under plastic...
412
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
376
Deformations in a Symmetric Member in Bending01:18

Deformations in a Symmetric Member in Bending

When analyzing the deformation of a symmetric prismatic member subjected to bending by equal and opposite couples, it becomes clear that as the member bends, the originally straight lines on its wider faces curve into circular arcs, with a constant radius centered at a point known as Point C. This phenomenon helps to understand the stress and strain distribution within the member more clearly.
When the member is segmented into tiny cubic elements, it is observed that the primary stress...
485