Feasibility of Fully Automated Hypnosis, Analgesia, and Fluid Management Using 2 Independent Closed-Loop Systems

Alexandre Joosten1, Vincent Jame2, Brenton Alexander3

  • 1From the Department of Anesthesiology, Cliniques Universitaires de Bruxelles Erasme, Université Libre de Bruxelles, Brussels, Belgium.

Related Concept Videos

Open and closed-loop control systems01:17

Open and closed-loop control systems

Control systems are foundational elements in automation and engineering. They are broadly categorized into open-loop and closed-loop systems. These classifications hinge on the presence or absence of feedback mechanisms, significantly influencing the system's performance, complexity, and application.
An open-loop control system operates without feedback from the output. It consists of two primary elements: the controller and the controlled process. The controller receives an input signal...
1.6K
Analgesia and Pain Management01:25

Analgesia and Pain Management

Pain is critical to various clinical pathologies, provoking an urgent need for effective management. Pain, whether acute or chronic, is a complex neurochemical process. Its alleviation depends on the type, with nonopioid analgesics effective for mild to moderate pain, such as musculoskeletal or inflammatory pain, while neuropathic pain responds best to anticonvulsants, tricyclic antidepressants, or serotonin/norepinephrine reuptake inhibitors. For severe acute or chronic pain, opioids may be...
1.5K
Seedless Vascular Plants03:24

Seedless Vascular Plants

Seedless Vascular Plants Were the First Tall Plants on Earth
66.7K
Pilot and Numeric Relaying01:21

Pilot and Numeric Relaying

Pilot relaying is a type of differential protection used in power systems. It compares electrical quantities at the terminals of equipment via a communication channel instead of direct relay interconnection. This method is essential for transmission lines where the terminals are far apart, typically up to 80 km for lines with 69 to 115 kV ratings. Four types of communication channels are used for pilot relaying:
485
Introduction to Test of Independence01:21

Introduction to Test of Independence

In statistics, the term independence means that one can directly obtain the probability of any event involving both variables by multiplying their individual probabilities. Tests of independence are chi-square tests involving the use of a contingency table of observed (data) values.
The test statistic for a test of independence is similar to that of a goodness-of-fit test:
2.9K
Hypothesis Test for Test of Independence01:16

Hypothesis Test for Test of Independence

The test of independence is a chi-square-based test used to determine whether two variables or factors are independent or dependent. This hypothesis test is used to examine the independence of the variables. One can construct two qualitative survey questions or experiments based on the variables in a contingency table. The goal is to see if the two variables are unrelated (independent) or related (dependent). The null and alternative hypotheses for this test are:
H0: The two variables (factors)...
7.4K