Related Experiment Video
Updated: Jan 24, 2026

The Effect of Construction and Demolition Waste Plastic Fractions on Wood-Polymer Composite Properties
Published on: June 7, 2020
Cutting Boards of Plastic and Wood Contaminated Experimentally with Bacteria
Nese O Ak1,2, Dean O Cliver1,3, Charles W Kaspar1
1Food Research Institute (Department of Food Microbiology and Toxicology), University of Wisconsin-Madison, Madison, Wisconsin 53706.
Abstract:
The microbiology of Plastic and wooden cutting boards was studied, regarding cross-contamination of foods in home kitchens. New and used Plastic (four polymers plus hard rubber) and wood (nine hardwoods) cutting boards were cut into 5-cm squares ("blocks"). Escherichia coli (two nonpathogenic strains plus type O157:H7), Listeria innocua , L. monocytogenes , or Salmonella typhimurium was applied to the 25-cm2 block surface in nutrient broth or chicken juice and recovered by soaking the surface in nutrient broth or pressing the block onto nutrient agar, within 3-10 min or up to ca. 12 h later. Bacteria inoculated onto Plastic blocks were readily recovered for minutes to hours and would multiply if held overnight. Recoveries from wooden blocks were generally less than those from plastic blocks, regardless of new or used status; differences increased with holding time. Clean wood blocks usually absorbed the inoculum completely within 3-10 min. If these fluids contained 103-104 CFU of bacteria likely to come from raw meat or poultry, the bacteria generally could not be recovered after entering the wood. If ≥106 CFU were applied, bacteria might be recovered from wood after 12 h at room temperature and high humidity, but numbers were reduced by at least 98%, and often more than 99.9%. Mineral oil treatment of the wood surface had little effect on the microbiological findings. These results do not support the often-heard assertion that Plastic cutting boards are more sanitary than wood.
Related Concept Videos
Wood Surfacing
The equipment used in the surfacing process is a plane equipped with rotating blades. This tool efficiently smoothens the wood surface and can...
Wood Fasteners
Nails are the most common fasteners, consisting of sharp-pointed metal pins that are driven into wood using a hammer or a mechanical nail gun. They come in a variety of diameters, heads, and lengths. Nailing techniques include...
Contaminants and Errors
Another key consideration is determining the appropriate number of samples required to...
Plasticizers
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
Plasticity
Introduction to Wood
The structural integrity of the...

