Related Experiment Video
Updated: Jan 24, 2026

Evaluation of Hepatic Glucose Production in a Polycystic Ovary Syndrome Mouse Model
Published on: March 5, 2022
Biohydrogen production from glucose using submerged dynamic filtration module: Metabolic product distribution and
Parthiban Anburajan1, Jong-Hun Park2, Arivalagan Pugazhendhi3
1School of Civil and Environmental Engineering, Yonsei University, Seoul 03722, Republic of Korea.
Abstract:
A lab scale bioreactor with the submerged polyester mesh of pore size 100 μm, was used for biohydrogen production under mesophilic condition (35 °C). The reactor was continuously fed with glucose (15 g/L) for 90 days with a hydraulic retention time (HRT), ranging from 12 to 1.5 h. Peak hydrogen yield (HY) was achieved at 3 h HRT as 3.22 ± 0.22 mol H2/mol glucose added and the hydrogen production rate was achieved at 2 h HRT as 54.07 ± 3.69 L H2/L-d, respectively. When HRT was reduced to 1.5 h, the hydrogen yield decreased to 1.04 ± 0.44 mol H2/mol glucose added. Washout of the hydrogen producing population and metabolic flux shift to non-hydrogen producing at 1.5 h HRT might have attributed to the lower performance of the bioreactor.
Related Concept Videos
Filtration and Urine Formation
Scalar Product (Dot Product)
The scalar product of two vectors is obtained by multiplying...
Vector Product (Cross Product)
Consider the cross product of two vectors. Imagine rotating the first vector about...
Wood Products
Glue-laminated wood, often referred to as glulam, combines multiple smaller pieces of dimensional lumber using adhesives to form a single, larger piece. Cross-laminated timber consists...
Dot Product
In engineering, the dot product of any two vectors is the product of the magnitudes of the vectors and the cosine of the angle between them. It is denoted by a dot symbol between the two vectors.
Consider a vehicle pulling an object along the ground using a rope. If the rope makes an angle with the horizontal axis, the work done can be calculated using the dot product of the force applied and the object's displacement.
The dot...
Cross Product
The magnitude of the cross product is obtained by multiplying the magnitude of both the vectors and the sine of the angle between them. This means that a larger angle between the vectors will lead to a greater magnitude of the cross product.

