Differences in bleeding patterns and outcome after intracerebral hemorrhage due to vascular malformations

Nazife Dinc1, Sae-Yeon Won1, Nina Brawanski1

  • 1Department of Neurosurgery, Goethe University Hospital, Frankfurt, Germany.

Plos One
|May 24, 2019
PubMed
Abstract

Related Concept Videos

Bleeding in Fresh Concrete01:22

Bleeding in Fresh Concrete

Bleeding in fresh concrete occurs when water from the mix rises to the surface. This happens because the mix's solid components fail to retain all the water as they settle, leading to separation where water collects at the top. The severity of bleeding can be measured by assessing the total settlement or by noting the decrease in height per unit height of concrete.
Bleeding can cause several issues in the concrete structure. Sometimes, the rising water gets trapped beneath large aggregate...
560
Predicting Reaction Outcomes02:24

Predicting Reaction Outcomes

Kinetics describes the rate and path by which a reaction occurs. In contrast, thermodynamics deals with state functions and describes the properties, behavior, and components of a system. It is not concerned with the path taken by the process and cannot address the rate at which a reaction occurs. Although it does provide information about what can happen during a reaction process, it does not describe the detailed steps of what appears on an atomic or a molecular level. On the other hand,...
10.4K
Outcomes of Glycolysis01:13

Outcomes of Glycolysis

Nearly all the energy used by cells comes from the bonds that make up complex organic compounds. These organic compounds are broken down into simpler molecules, such as glucose. As a result, cells extract energy from glucose over many chemical reactions—a process called cellular respiration.
Cellular respiration can occur aerobically (with oxygen) or anaerobically (without oxygen). In the presence of oxygen, cellular respiration starts with glycolysis and continues with pyruvate...
106.8K
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.1K
Electric Potential and Potential Difference01:16

Electric Potential and Potential Difference

Suppose a positive test charge moves away from a positive static charge, then the Coulomb force does positive work, and its electric potential energy decreases. The potential energy per unit charge is defined as the electric potential. The electric potential is independent of the test charge.
When a test charge moves from the initial to the final position, the electric potential difference between those positions is defined as the ratio of the change in the potential energy to the charge on the...
5.6K
Seedless Vascular Plants03:24

Seedless Vascular Plants

Seedless Vascular Plants Were the First Tall Plants on Earth
66.7K