Related Experiment Video
Updated: Jan 24, 2026

Standard Operating Procedure for Lyssavirus Surveillance of the Bat Population in Taiwan
Published on: August 27, 2019
Bat flies aggregation on Artibeus planirostris hosts in the Pantanal floodplain and surrounding plateaus
Esther Gonçalves Morimatsu Vieira1, Erich Fischer2, Gustavo Graciolli2
1Licenciatura em Ciências Biológicas, Instituto de Biociências, Universidade Federal de Mato Grosso do Sul, 79070-900 Campo Grande, Brasil.
Abstract:
For parasites in natural systems, the most common pattern of spatial distribution is aggregation among hosts. The main causes of such aggregation are variable exposure of hosts to parasites and heterogeneity in host susceptibility. The objective of this study was to determine if there are differences in the aggregation pattern of two species of ectoparasitic flies between the Pantanal and Cerrado regions of Brazil on the bat Artibeus planirostris. We collected the ectoparasites from bats captured between 2002 and 2017 with mist nets in 21 sites in the Pantanal and 15 sites in the surrounding plateaus. The results showed that the aggregation of ectoparasitic flies in Pantanal was more pronounced than in Cerrado. The discrepancy aggregation index (D) of the bat fly Megistopoda aranea was 0.877 in Pantanal and 0.724 in Cerrado. The D values of Aspidoptera phyllostomatis was even higher, with 0.916 and 0.848 in the Pantanal and Cerrado, respectively. Differences in the shelters used may be the main factor shaping variation in aggregation, since the Pantanal does not have rock formations, with only foliage, crowns and hollow tree trunks. These differences likely affect host exposure to the parasites, leading to an increase in parasite aggregation.
Related Concept Videos
Aggregates Classification
Petrographic classification groups aggregates based on common mineralogical characteristics. Some of the common mineral groups found in aggregates are...
Bonding and Strength of Aggregate
Specific Gravity of Aggregate
Bulk or gross specific gravity is calculated by taking the ratio of the mass of aggregates in the saturated surface-dry state to the total volume that includes both the solids and the voids within the...
Bulk Density of Aggregate
Most natural mineral aggregates, like sand and gravel,...
Design Example: Aggregate Gradation
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is...
Toughness and Hardness of Aggregate

