Reflection and transmission characteristics of Lamb waves at an adhesive lap joint of plates

The reflection and transmission characteristics of Lamb waves at an adhesive single lap joint of plates are examined theoretically by the hybrid finite element method. The adhesive joint is modeled by a linear spring-type interface, which is characterized by normal and tangential stiffnesses. For the incidence of the lowest-order antisymmetric (A0) Lamb mode in a low frequency range, it is shown that the reflection and transmission coefficients of the A0 mode take local maxima and minima at multiple frequencies. This behavior results from the interference of waves originating from the lowest-order antisymmetric guided wave mode in the overlap region. The peak frequencies of the transmission coefficient increase monotonically with increasing tangential stiffness, but are almost invariant with the normal stiffness of the adhesive joint. Furthermore, time-domain numerical simulation using the finite element method is carried out to discuss the theoretical results. As a result, for the A0 mode incidence, the reflection and transmission waveforms of the A0 mode from the lap joint are found to show long-oscillation tails. The spectral analysis for the obtained waveforms shows that these tails are necessary to identify the frequencies at which the reflection and transmission coefficients take local maxima and minima.