Histone deacetylase activity mediates thermal plasticity in zebrafish (Danio rerio)

Frank Seebacher1, Alec I M Simmonds2

  • 1School of Life and Environmental Sciences, The University of Sydney, Sydney, NSW, 2006, Australia. frank.seebacher@sydney.edu.au.

Scientific Reports
|June 5, 2019
PubMed

Related Concept Videos

Histone Modification02:32

Histone Modification

The histone proteins have a flexible N-terminal tail extending out from the nucleosome. These histone tails are often subjected to post-translational modifications such as acetylation, methylation, phosphorylation, and ubiquitination. Particular combinations of these modifications form “histone codes” that influence the chromatin folding and tissue-specific gene expression.
Acetylation
The enzyme histone acetyltransferase adds acetyl group to the histones. Another enzyme, histone...
16.0K
Histone Modification02:32

Histone Modification

4.4K
Co-activators and Co-repressors02:04

Co-activators and Co-repressors

Gene transcription is regulated by the synergistic action of several proteins that form a complex at a gene regulatory site. This is observed in eukaryotes, where the regulation of gene expression is a complex process. Regulatory proteins in eukaryotes can broadly be classified into two types – regulators that bind directly to specific DNA sequences and co-regulators that associate with regulatory proteins but cannot directly bind to the DNA. These co-regulators are further divided into...
8.4K
Histone Variants at the Centromere02:30

Histone Variants at the Centromere

Histone variants are the histone proteins with structural and sequence variations. These variants may be regarded as “mutant” forms that replace their canonical histone counterparts in the nucleosomes. Specific post-translational modifications on the histone variants enable further chromatin complexity and regulate tissue-specific gene expression. The most common histone variants are from histone H2A, H2B, and linker histone H1 families. However, several variants of histone H3...
5.0K
Cycloaddition Reactions: MO Requirements for Thermal Activation01:16

Cycloaddition Reactions: MO Requirements for Thermal Activation

Thermal cycloadditions are reactions where the source of activation energy needed to initiate the reaction is provided in the form of heat. A typical example of a thermally-allowed cycloaddition is the Diels–Alder reaction, which is a [4 + 2] cycloaddition. In contrast, a [2 + 2] cycloaddition is thermally forbidden.
4.3K
Plasticizers01:31

Plasticizers

Water-reducers, or plasticizers, are chemical admixtures used in concrete to improve strength and workability. These additives reduce the water-cement ratio without compromising workability, lower the cement content while maintaining the same workability, or increase workability to assist concrete placement in inaccessible areas.
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
353