Determination of pH Effects on Phosphatidyl-Hydroxytyrosol and Phosphatidyl-Tyrosol Bilayer Behavior

A robust method was developed to investigate the liposomal behavior of novel enzymatically-synthesized hydroxytyrosol and tyrosol phospholipids. Bilayer characteristic obtained by this method, including bilayer formation stability and adsorption properties, were explored using dynamic light scattering, zeta-potential measurements, and quartz crystal microbalance with dissipation monitoring (QCMD), respectively. Liposome diameters were found to typically increase from pH 5.5 to pH 10. Zeta potentials values, on the other hand, were found to be well below -25 mV at all pH conditions explored, with the lowest values (and thus, the best liposome stability) at pH 5.5 or pH 10. Quartz crystal microbalance with dissipation monitoring measurements demonstrated that 100% 1,2-dioloeoylphosphatidyl-hydroxytyrosol (DOPHT) liposomes adsorbed intact onto silica in buffer conditions at pH 5.5 and with no calcium, or at pH 7.5 with calcium (no adsorption was detected at pH 10). 1,2-Dioleoylphosphatidyl-tyrosol (DOPT) liposomes were shown to adsorb intact under buffer conditions only at pH 5.5 with and without calcium. 1,2-Dioleoylphosphatidyl-2-phenolethanol (DOPPE), in comparison, readily adsorbed intact at pH 7.5 without calcium and just slightly at pH 5.5 with calcium present, but formed a supported bilayer over hours at pH 5.5 in the absence of calcium ions.