Circuit mechanisms for the maintenance and manipulation of information in working memory

Nicolas Y Masse1, Guangyu R Yang2,3, H Francis Song2,4

  • 1Department of Neurobiology, The University of Chicago, Chicago, IL, USA. masse@uchicago.edu.

Nature Neuroscience
|June 12, 2019
PubMed

Related Concept Videos

Maintenance of the ES Cell State01:14

Maintenance of the ES Cell State

The cells of the blastocyst inner cell mass only remain pluripotent for a short time. This state of pluripotency and self-renewal can be maintained in embryonic stem (ES) cell culture by adding specific chemicals or growth factors to ensure the cells can continue dividing and later differentiate into different cell types. In some cases, the cells are grown on a feeder layer of differentiated cells, which provides the growth factors and extracellular matrix components necessary for stem cell...
2.7K
System of Memory01:23

System of Memory

Memory is categorized into three major systems: sensory memory, short-term memory (STM), and long-term memory (LTM). These systems differ in their capacity and the duration for which they can hold information. Sensory memory captures raw sensory input from the environment, holding it for just a few seconds or less. For example, on hearing a brief, loud sound, like a car horn honking, the sound seems to linger in the mind for a moment even after it stops. This is an instance of sensory memory...
7.3K
Working Memory01:24

Working Memory

Working memory refers to a combination of components, including short-term memory and attention, that allow an individual to hold information temporarily as we perform cognitive tasks. It is an essential cognitive function that enables the execution of complex tasks such as problem-solving, comprehension, and reasoning. Unlike short-term memory, which simply involves the storage of information for a brief period, working memory involves the active manipulation and processing of this...
839
Second-Order Circuits01:17

Second-Order Circuits

Integrating two fundamental energy storage elements in electrical circuits results in second-order circuits, encompassing RLC circuits and circuits with dual capacitors or inductors (RC and RL circuits). Second-order circuits are identified by second-order differential equations that link input and output signals.
Input signals typically originate from voltage or current sources, with the output often representing voltage across the capacitor and/or current through the inductor. For example, in...
3.3K
First-Order Circuits01:15

First-Order Circuits

First-order electrical circuits, which comprise resistors and a single energy storage element - either a capacitor or an inductor, are fundamental to many electronic systems. These circuits are governed by a first-order differential equation that describes the relationship between input and output signals.
One common example of a first-order circuit is the RC (resistor-capacitor) circuit. These circuits are used in relaxation oscillators such as neon lamp oscillator circuits. When voltage is...
3.3K
The Y-to-Y Circuit01:19

The Y-to-Y Circuit

In a balanced four-wire wye-to-wye system, the arrangement involves wye-connected sinusoidal voltage sources and loads, connected through a neutral wire that links the neutral nodes of the source and load. The load impedance is connected across each phase of the load. The wye-connected source can be connected to the wye-connected load in four-wire and three-wire arrangements. A three-phase system is considered balanced when the load on each phase is equal, leading to uniform current flow and...
736