Solutions to Reduce Unnecessary Imaging-Reply
These videos have been matched automatically. Contact us if they are not relevant.
These videos have been matched automatically. Contact us if they are not relevant.
These videos have been matched automatically. Contact us if they are not relevant.
These videos have been matched automatically. Contact us if they are not relevant.
Related Concept Videos
371
In a three-phase circuit, line loss is an indicator of energy dissipated as heat due to the resistance of transmission lines. To address this, incorporating transformers into the system—a step-up transformer at the source and a step-down transformer at the load—is a strategic solution. Two three-phase transformers are introduced to improve this.
With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss in...
22.3K
According to Raoult’s law, the partial vapor pressure of a solvent in a solution is equal or identical to the vapor pressure of the pure solvent multiplied by its mole fraction in the solution. However, Raoult's Law is only valid for ideal solutions. For a solution to be ideal, the solvent-solute interaction must be just as strong as a solvent-solvent or solute-solute interaction. This suggests that both the solute and the solvent would use the same amount of energy to escape to the...
35.5K
Many common substances around us exist as a solution, such as ocean water, air, and gasoline. All solutions are mixtures of substances that are composed of varying amounts of two or more types of atoms or molecules. A mixture with a non-uniform composition is a heterogeneous mixture, whereas a mixture with a uniform composition is a homogeneous mixture. The components that make the homogeneous mixture are evenly spread out and thoroughly mixed.
A solution is a homogeneous mixture that is...
37.0K
There is no one solvent that can dissolve every type of solute. Some substances that readily dissolve in a certain solvent might be insoluble in a different solvent. A simple way to predict which substances dissolve in which solvent is the phrase "like dissolves like". This means that polar substances, such as salt and sugar, dissolve in a polar substance like water. In contrast, non-polar substances are more soluble in non-polar solvents such as carbon tetrachloride.
This selective...
30.2K
There are two criteria that favor, but do not guarantee, the spontaneous formation of a solution:
A decrease in the internal energy of the system (an exothermic change, as discussed in the previous chapter on thermochemistry)
An increased dispersal of matter in the system (which indicates an increase in the entropy of the system, as you will learn about in the later chapter on thermodynamics)
In the process of dissolution, an internal energy change often, but not always, occurs as heat is...
2.4K
Standard solutions refer to solutions with a precisely known concentration or composition. A primary standard is a highly pure, high molar mass, stable substance that is entirely soluble in water, the most commonly used solvent in analytical chemistry. The primary standard solution can be used to standardize secondary standards, which are substances with known concentrations but are less pure and stable. Standard solutions are essential for achieving accurate and reliable results in analytical...