Related Experiment Video
Updated: Jan 23, 2026

Terahertz Microfluidic Sensing Using a Parallel-plate Waveguide Sensor
Published on: August 30, 2012
In-band pumping of Tm:LiYF4 channel waveguide: a power scaling strategy for ∼2 μm waveguide lasers
Abstract:
We report on a novel power scaling strategy for thulium waveguide (WG) lasers relying on in-band pumping by high-brightness Raman fiber lasers (RFLs) and the use of liquid-phase-epitaxy-grown fluoride crystalline thin films for better thermal management. Thulium channel WGs are produced by microstructuring the Tm3+:LiYF4/LiYF4 epitaxies via diamond-saw dicing. They are pumped by a RFL based on an erbium master oscillator power amplifier and a GeO2-doped silica fiber and emit polarized output at 1679 nm. A CW in-band-pumped (H63→F43) Tm3+:LiYF4 WG laser generates up to 2.05 W of a linearly polarized single-transverse-mode output at 1881 nm with a slope efficiency of 78.3% and a laser threshold of only 12 mW (versus the absorbed pump power).
Related Concept Videos
Band Theory
The energy difference between these bands is known as the band gap.
Conductor, Semiconductor,...
ATP Driven Pumps III: V-type Pumps
The peripheral or cytosolic V1 domain with eight subunits is involved in ATP hydrolysis. The integral or transmembrane V0 domain containing at least five subunits...
ATP Driven Pumps II: P-type Pumps
A typical P-type pump has three cytosolic domains: nucleotide-binding (N), phosphorylation (P), and activator (A) domains. These domains are connected to the membrane-spanning helices by short amino acid segments. ATP hydrolysis and covalent phosphoenzyme intermediate formation are crucial parts of the catalytic cycle. At the highly...
pH Scale
Energy Bands in Solids
Band Formation:
When atoms are brought close together, as in a solid, these discrete energy levels begin to split due to the overlap of electron orbitals from adjacent atoms. This split occurs because of the Pauli exclusion principle, which states...
Pumped Concrete
For direct-acting pumps, the concrete enters the pump via the inlet valve under the action of gravity and suction created by the movement of the piston. This concrete is then forced into the pipeline and out through the outlet valve by the forward movement...

