Related Experiment Video
Updated: Jan 23, 2026

A Mouse Distraction Osteogenesis Model
Published on: November 14, 2018
Articulated Joint Distraction in a Cadaveric Model of the Canine Elbow
Stephen Q Garofolo1, Michael G Conzemius1
1Department of Veterinary Clinical Sciences, University of Minnesota College of Veterinary Medicine, Saint Paul, MN, United States.
Objective:
The aim of this study was to determine if articulated joint distraction in the canine elbow can effectively maintain a distraction gap between the articular surfaces of the canine elbow under a weight-bearing load.
Study Design:
An articulated external skeletal fixator with turnbuckles was applied to seven canine cadaveric elbow specimens. Specimens were potted and mechanically tested at 135° of flexion, while joint contact pressure was recorded at three locations within the elbow. Joint distraction was sequentially increased, and loads of 5 N, 90 N and 180 N were incrementally applied. This process was repeated until no pressure was recorded at each of the three locations within the elbow under 180 N of applied load.
Results:
To achieve 0 N of joint contact force with 180 N of axial load, the average amount of distraction needed was 2.3 ± 0.71 mm (range, 1.8-3.6 mm) at the distal turnbuckles and 1.67 ± 1.10 mm (range, 1.8-2.7 mm) at the proximal turnbuckles.
Conclusion:
Results suggest that joint distraction can effectively decrease articular pressure within the canine elbow joint. A maximum of 3.6 mm of distraction between the fixator turnbuckles was necessary to eliminate joint contact for the construct tested. Clinical investigation is necessary to establish if articulated elbow joint distraction is a safe and effective for the treatment of canine elbow osteoarthritis.
More Related Videos
09:26An Efficient and Reproducible Protocol for Distraction Osteogenesis in a Rat Model Leading to a Functional Regenerated Femur
Published on: October 23, 2017
04:36Vacuum-Sealed Hot Water Bath Immersion for the Preparation of Anatomical and Surgical Cadaveric Bone Models
Published on: December 2, 2022
Related Concept Videos
Articulations of the Vertebral Column
Structural Joints: Synovial Joints
Structural Joints: Fibrous Joints
Suture
All the bones of the skull, except for the mandible, are joined to each other by a fibrous joint called a suture. The fibrous connective tissue found at a suture strongly unites the adjacent skull bones and thus helps to protect the brain and form the face. In...
Structural Joints: Cartilaginous Joints
There are two types of cartilaginous joints:
Synchondrosis
A synchondrosis ("joined by cartilage") is a cartilaginous joint where bones are connected by hyaline cartilage. Synchondrosis may be temporary...
Joints
Structural joint classifications are based on the material that makes up the joint as well as whether or not the joint contains a space between the bones. Joints are structurally classified as fibrous, cartilaginous, or synovial.
Fibrous Joints Are Immovable
The bones of a...
Introduction to Joints