Early Experience and Results Using Patient-Reported Outcomes Measurement Information System Scores in Primary Total

Kelly R Stiegel1, Jonathan G Lash1, Andrew J Peace1

  • 1Joseph Barnhart Department of Orthopedic Surgery, Baylor College of Medicine, Houston, TX.

Abstract

Related Concept Videos

Data Reporting and Recording01:24

Data Reporting and Recording

Reporting and recording are crucial in data documentation. The timely, thorough, and accurate documentation of facts is essential when recording patient data. Failure to record findings during an assessment or interpretation of a problem will result in loss of information and make the patient document unreliable. The reader is left with general impressions if the information is not specific. A recording is documenting data of the individual's health information in a traceable, secure, and...
5.4K
Knee Joint01:23

Knee Joint

The knee joint is the most complicated joint in the body. It consists of three articulations– two tibiofemoral and one patellofemoral. As is characteristic of synovial joints, the knee joint has a thin articular capsule that partially surrounds this joint cavity. Additionally, several ligaments, muscles, and cartilaginous structures support the movement of the knee.
A total of seven ligaments support the knee joint. The patellar ligament, which is also attached to the quadriceps femoris...
3.1K
Introduction to z Scores01:06

Introduction to z Scores

A z score (or standardized value) is measured in units of the standard deviation. It tells you how many standard deviations the value x is above (to the right of) or below (to the left of) the mean, μ. Values of x that are larger than the mean have positive z scores, and values of x that are smaller than the mean have negative z scores. If x equals the mean, then x has a zero z score. It is important to note that the mean of the z scores is zero, and the standard deviation is one.
z scores...
11.0K
Introduction to z Scores01:05

Introduction to z Scores

A z score (or standardized value) is measured in units of the standard deviation. It indicates how many standard deviations the value x is above (to the right of) or below (to the left of) the mean, μ. Values of x that are larger than the mean have positive z scores, and values of x that are smaller than the mean have negative z scores. If x equals the mean, then x has a zero z score. It is important to note that the mean of the z scores is zero, and the standard deviation is one.
z scores...
1.2K
z Scores and Area Under the Curve01:17

z Scores and Area Under the Curve

z scores are the standardized values obtained after converting a normal distribution into a standard normal distribution. A z score is measured in units of the standard deviation. The z score tells you how many standard deviations the value x is above (to the right of) or below (to the left of) the mean, μ. Values of x that are larger than the mean have positive z scores, and values of x that are smaller than the mean have negative z scores. If x equals the mean, then x has a z score of...
18.4K
Predicting Reaction Outcomes02:24

Predicting Reaction Outcomes

Kinetics describes the rate and path by which a reaction occurs. In contrast, thermodynamics deals with state functions and describes the properties, behavior, and components of a system. It is not concerned with the path taken by the process and cannot address the rate at which a reaction occurs. Although it does provide information about what can happen during a reaction process, it does not describe the detailed steps of what appears on an atomic or a molecular level. On the other hand,...
10.3K